User manual CREDA HB42207

[. . . ] Inside the pack containing this manual, you will also find the guarantee and all the details necessary for installation. If the appliance is levelled correctly, it will be more stable and much less likely to cause vibrations and noise while it is operating, particularly during the spin cycle. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing machine. Connecting the electricity and water supplies Connecting the water inlet hose ! [. . . ] To remove the delayed start option, press the button until the display shows the text OFF; the symbol will disappear. € Press the button to activate the option; the name of the option will then appear on the display and the corresponding indicator light will illuminate. € Press the button again to deactivate the option; the name of the option will then appear on the display followed by the text OFF, and the corresponding indicator light will switch off. If the selected option is not compatible with the selected wash cycle, this incompatibility will be signalled by the flashing of the indicator light and a sound alert (3 beeps); the option will not be activated. If the selected option is not compatible with another option that has been selected previously, the indicator light corresponding to the first option selected will flash and only the second option will be activated; the indicator light corresponding to the button will remain lit in a constant manner. The options may affect the recommended load value and/or the duration of the cycle. 90°C) 40° 40° 40° 40° 1200 1200 1200 1200 600 800  -             9 9 9 9 2 4 The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation 2010/1061: set wash cycle with a temperature of 60°C and 40°C. 2) Long wash cycle for cottons: set wash cycle with a temperature of 40°C. The detergent should be poured into the relevant compartment - or the dispenser placed directly inside the drum - before the wash cycle begins. In the latter case, it will not be possible to select the Cottons with pre-wash cycle. Do not use hand washing detergents because these create too much foam. € Shake out the garments before loading them into the machine. € Divide the laundry according fabric type (symbol on the washing instruction label) and colour, making sure you separate the coloured garments from the white ones; • Empty all pockets and check the buttons; • Do not exceed the values listed in the “Table of wash cycles”, which refer to the weight of the laundry when dry. Detergent Preparing the laundry How much does 1 sheet 1 pillowcase 1 tablecloth 1 bathrobe 1 towel 1 pair of jeans 1 shirt your laundry weigh?400-500 g 150-200 g 400-500 g 900-1200 g 150-250 g 400-500 g 150-200 g wash cycle to wash shirts Shirts: use the special “Shirts” in different fabrics and colours to guarantee they receive the best possible care. Jeans: use the special “Jeans” wash cycle for all denim garments; turn inside out before washing and use a liquid detergent. Baby: use the special “Baby” wash cycle to remove the remove the soiling typically caused by babies, while removing all traces of detergent from nappies in order to prevent the delicate skin of babies from suffering allergic reactions. The cycle has been designed to reduce the amount of bacteria by using a greater quantity of water and optimising the effect of special disinfecting additives added to the detergent. At the end of the wash cycle, the machine will slowly rotate the drum; to end the cycle press the START/PAUSE button. [. . . ] € If you have selected the “Baby ” cycle or the “Easy iron ” option, when the wash cycle has finished the machine will slowly rotate the drum; to end the cycle press the START/PAUSE button or the “Easy iron ” button. If you have selected the “Silk ” wash cycle, the machine will end the cycle while the laundry is soaking; to drain the water so that the laundry may be removed, press the START/PAUSE button or the “Easy iron ” button. € The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). € The free end of the hose is under water (see “Installation”). [. . . ]