User manual CREDA HB42311

[. . . ] Pass them on to possible new owners of the appliance. Ventilation To ensure adequate ventilation is provided, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). Keep packaging material out of the reach of children. [. . . ] This mode is ideal for baking temperature sensitive foods (such as cakes, which need to rise) and for the preparation of “bitesize pastries” on 3 shelves simultaneously. Place the rotisserie support in position 3 and insert the spit in the hole provided on the back panel of the oven. Start the rotisserie using the knob to select MODES or . Do not place racks in position 1 or 5 during fanassisted cooking. In the GRILL and GRATIN cooking modes, place the dripping pan in position 1 to collect cooking residues (sauce and/or grease). MULTILEVEL • Use positions 2 and 4, placing the food which requires more heat on the rack in position 2. € Place the dripping pan on the bottom and the rack on top. gRILL • Place the rack in position 3 or 4. Make sure the food is in the centre of the rack. € We recommend that the power level is set to maximum. The top heating element is regulated by a thermostat and may not always operate constantly. They turn red approximately ten seconds after they have been turned on. Each cooking zone is fitted with a control knob allowing you to select from 12 different temperature settings from a minimum of 1 to a maximum of 12. The glue that is applied on the gaskets leaves some traces of grease on the glass. Before using the appliance, we recommend you eliminate these with a special non-abrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. To obtain the best results with your hob: • Use flat-bottomed pans to ensure that they adhere to the cooking zone perfectly. Extendable cooking zones The extendable radiant elements (B) are recognisable by the fact that they have a double heating zone. You can turn on only the smaller internal cooking zone or both the external and internal zones. The control knob allows you to choose between two power levels, which are both adjustable between a minimum value of 1 to a maximum of 12: • The lowest power level can be set by turning the knob clockwise from 1 to 12. € Turn the knob to completely (A) until you hear a slight click, to enable the maximum power level, which in turn can be adjusted between 12 and 1 by turning the knob anticlockwise. To restore the minimum power level, turn the knob and set it back to position 0. [. . . ] If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced. Cleaning the appliance • The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. [. . . ]