User manual CREDA HB49501

[. . . ] This symbol reminds you to read this booklet. 1 Important Information GB For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter. You MUST clean the fluff filter after EVERY drying cycle. Open the filter and clean any fluff deposits from the filter mesh. [. . . ] When timed programmes are selected the time displayed throughout the cycle is the actual time remaining. When an Automatic programme is selected, the time displayed is an estimate of the time remaining. When the programme is selected the display shows the time required to dry a full load, after around 10 minutes the controller calculates a better estimate of the cycle time. The colons between the hours and minutes in the display flash to show that the time is counting down. The display also shows if there is a problem with your dryer, if this occurs the display will show F followed by a fault code number (see Troubleshooting). — Empty Water Container (If you have plumbed your dryer to a drain this icon can be ignored, as there is no need to empty the water container). Messages are displayed to reminds you to empty the water container (see The Display). If the water container fills during a programme, the heater turns off and the dryer does a period of Cool Tumble. After this it stops and a message tells you to EMPTY THE WATER CONTAINER . You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the dryer the message will take a few seconds to go out. The post-care option occasionally tumbles the clothes after end of the drying and cool tumble cycles to prevent creases developing, should you not be available to remove the load immediately the programme is complete. Note: The Start/Pause light flashes Amber during this phase. Selecting this option enables both the pre and post care functions if appropriate. high Heat Allows Low Heat to be selected on some programmes. When the light above this button is on High Heat is selected. Not all programmes allow you to change this setting. When High Heat is selected with the Refresh programme this selects the Heat & Enjoy cycle. Sound Available on all programmes and allows the buzzer to give a signal at the end of the drying cycle, to remind you that the clothes are ready to be removed. — TIME DISPLAY 88:88 The display shows either the amount of time delay remaining or an indication of the amount of time left for a drying programme (see The Display). The delay or time to end is displayed in hours and minutes and counts down each minute. 11 Laundry GB Sorting your laundry Check symbols on clothing labels to make sure that the articles can be tumble dried. [. . . ] For safety the dryer has a maximum programme time of 4 hours. Check the above points and run the programme again, if the results are still damp, contact the Service Centre (see Service). — The display shows a fault code F followed by one or two numbers. — If the display shows F10 or F15: - Turn off and remove the plug. [. . . ]