User manual CREDA HB86405

[. . . ] This appliance is designed for domestic use or similar applications, for example: - staff kitchen areas in shops, offices and other work environments; - farmhouses; - use by guests in hotels, motels and other residential settings; - bed and breakfasts. Connecting the water inlet hose • To a suitable cold water connection point: before attaching the hose, run the water until it is perfectly clear so that any impurities that may be present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. [. . . ] When using multi-functional tablets, press the MULTIFUNCTIONAL TABLETS symbol: the corresponding symbol will light up on the display. The “Multi-functional tablets” option results in the lengthening of the wash cycle. The MULTI-FUNCTIONAL TABLETS option remains set for subsequent wash cycles if it is not deselected. The use of tablets is only recommended when the MULTI-FUNCTIONAL TABLETS option is available. This option is not recommended for use with wash cycles which do not specify the use of multi-functional tablets (see Table of options). This option can be used to reduce the duration of the main wash cycles while maintaining the same washing and drying performance levels. After selecting the wash cycle, press the Short Time option symbol; the illumination of the corresponding symbol on the display indicates its selection. To deselect the option, press the same symbol again. The Short Time and Good Night options are not compatible with each other. The Short Time and Good Night options are not compatible with the HALF LOAD option. Baby Wash 19 Wash cycles EN For available OPTIONS please refer to the Table of options on the Start-up and use page. The rinse aid dispenser should be filled: • When the LOW RINSE AID* indicator light on the control panel/display is illuminated; 1. Open the dispenser by turning the lid (G) in an anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the dispenser. F If this happens, clean the spill immediately with a dry cloth. NEVER pour the rinse aid directly into the appliance tub. Loading the refined salt In order to achieve the best possible results using a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: the cap of the salt dispenser. • When the LOW RINSE AID* indicator light/symbol on the control panel/display is illuminated. • When the green float* cannot be seen by simply looking at Adjusting the amount of rinse aid If you are not completely satisfied with the drying results, you may adjust the quantity of rinse aid used. Use a screwdriver to turn the dosage adjuster (F) to one of the 6 pre-set positions (the default position is set to 4): • If there are streaks on the crockery, set the adjustment device to a lower number (1-3). [. . . ] The The The The dish wash er cyc le h as not yet finished. The dishes are rattl ing agai n st each other or a gainst the s prayer a rm s. An e xcessive am ount of fo a m has been produce d: the d eterg ent has not been m easure d out correctly or it is not suitable for use i n dish washe rs (see Start-u p and use). The level of the refi ned salt is low o r the dosa ge setting is not suited to the hardness of the wate r (see Rinse ai d and s alt). [. . . ]