User manual CREDA HBT512VW

[. . . ] Tumble Dryer Instruction Book 5kg Models You must read these instructions prior to using the appliance and retain them for future reference. Contents Safety Advice Electrical Requirements Features - Get to know the main parts of your Dryer Where to put and vent your Dryer How to use your Dryer The Controls Sorting your laundry Wash Care Labels Items not suitable for tumble drying Items requiring special attention Speedy Iron Programme Guide to Drying Times How to remove and clean the fluff filter Caring for your Dryer If something goes wrong Key Contacts 3-4 5 6 7-8 9 10-13 14 15 15 16 17 18 19 20 22 Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance. If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also provided so the new owner can become familiar with the appliance and safety warnings. If the Book is lost or damaged a copy may be obtained from: GDA Ltd. , Morley Way, Peterborough, PE2 9JB 2 For your safety IMPORTANT Using your Tumble Dryer is easy. Nevertheless, for your own safety and to get the best results it is important to know your Dryer by reading right through this handbook before using your dryer for the first time. NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER q Allow children to play with or otherwise interfere with the dryer. [. . . ] · Small loads (less than 1kg) must be dried using the timed drying programme. 12 i) Automatic Drying The Controls - Auto Sensor models (continued) Sensor Drying Light ii) Speedy Iron Cycle This light will glow when Sensor Drying is selected. it will stop glowing when the load is dry and the programme advances to the Cool Tumble phase. This is a short programme of approximately 10 minutes to condition previously dried clothes (See section "Speedy Iron Programme"). It consists of a period of heating followed by a short cool tumble period (as detailed below). It should not be used on damp loads, as it is NOT a drying programme. To set the required time, all you have to do is turn the timer control clockwise until the required time appears in line with the indicator. Never turn the timer control anti-clockwise. The chart in the section "Guide to Drying Times" will tell you how much time you'll need for various loads. This programme is particularly useful in cases where a damp load is required for ironing or LOW heat drying is required and also for small loads. About 10 minutes before the programme is completed, the heating elements are switched off and the programme enters the final `Cool Tumble" phase. You should always allow the dryer to complete this phase. By opening the door the dryer will stop and you can check the dryness of the load as often as you wish and if you want to remove (or add) some items before they are fully dry. (This is particularly useful for a mixed load where you want to iron some items, but others are to be fully dried). After this cycle, the ready signal (Alarm) will sound (if selected) to remind you that the clothes are ready to take out. To cancel, turn the timer to `0' or press the option button (to its OUT position). We recommend that the clothes Are removed immediately this programme ends to minimise creasing. iii) Timed Drying iv) Cool Tumble Phase 13 Sorting your laundry 1. Always separate laundry into the correct fabric groups before washing and drying. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage. It is important to extract as much water as possible from each item before drying. WARNING: CLOTHES SHOULD NEVER BE LOADED DRIPPING WET 4. [. . . ] To help the environment Local Authority instructions should be followed for the disposal of your product. This appliance conforms to the following EEC Directives. Low Voltage Equipment 72/23/EEC 93/68/EEC Electromagnetic Compatibility 89/336/EEC 92/31/EEC 93/68/EEC 21 If something goes wrong First, don't panic!Look for your problem below, then check the things we suggest. [. . . ]