User manual CREDA HBT622CW

[. . . ] Condensing Tumble Dryer Instruction Book You must read these instructions prior to using the appliance and retain them for future reference. Contents Safety Advice Electrical Requirements Features - Get to know the main parts of your Dryer Where to put your Dryer How to use your Dryer The Controls Sorting your laundry Wash Care Labels Items requiring special attention Emptying you Water Container Speedy Iron Programme Guide to Drying Times Caring for your Dryer If something goes wrong Key Contacts 3-4 5 6 7 8 9-11 12 13 14 15 16 17 18 20 Back Cover Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the appliance. If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also provided so the new owner can become familiar with the appliance and safety warnings. 2 For your safety IMPORTANT Using your Tumble Dryer is easy. Nevertheless, for your own safety and to get the best results it is important to know your Dryer by reading right through this handbook before using your dryer for the first time. [. . . ] Otherwise, the dryer starts the new selection. (iv) Speedy Iron Cycle Starting a Programme (Green Active light) Empty Water light The indicator light turns Orange during a drying programme when the water container is full. When this happens, you must empty the water container. You should not wait for this light to change colour before emptying the container, but empty it after each load (see section `Emptying the Water Container'). The programme goes directly to the cool tumble phase and the dryer stops. The Orange light warns you that the load will not be dried correctly. At the end of a drying programme if the container has filled the indicator light will glow Red. Empty the water container and start the programme again by pressing the Start button. The indicator light goes off (or turns Green if a programme is running) about 10 seconds after the water container has been put back. The `Cool Tumble' About 10 minutes before the programme is completed, the heating elements will be switched off, the programme enters the final `Cool phase Tumble' phase. During this period, the fabric is cooled. You should always allow the dryer to complete this phase. By opening the door, you can check the dryness of the load as often as you wish and if you want to, remove some items before they are fully dry. (This is particularly useful for a mixed load when you want to iron some items, but others to be fully dried). You will need to press the Start button after closing the door to re-start the programme. Always separate laundry into the correct fabric groups before washing and drying. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage. It is important to extract as much water as possible from each item before drying. WARNING: CLOTHES SHOULD NEVER BE LOADED DRIPPING WET 4. Make sure that the items to be dried are suitable for tumble drying, or are not of a type requiring `special attention' (see"Wash Care Labels" section). Maximum load size Your dryer will hold a load of 6kg (13lb) dry weight of natural fabrics. if you are drying items of man-made fibres (synthetic or acrylics), the maximum load should not exceed 3kg (6. 6lb) dry weight. [. . . ] To help the environment Local Authority instructions should be followed for the disposal of your product. This appliance conforms to the following EEC Directives. Low Voltage Equipment 72/23/EEC 93/68/EEC Electromagnetic Compatability 89/336/EEC 92/31/EEC 93/68/EEC 19 If something goes wrong First, don't panic!Look for your problem below, then check the things we suggest. [. . . ]