User manual CREDA HBW100FW

[. . . ] Mo del W 120VW is show n Washing Machine W100FW / W120FW / W120VW Retention of this Instruction Book Keep this book in a handy place for reference. It contains important details on the safe and proper use of your appliance. If you sell the appliance, pass it on to someone else, move house and leave it behind, make sure that you provide this book so that the new owner can become familiar with the appliance and safety warnings. Please remember your new appliance is a complex piece of equipment. [. . . ] Increases the water level of the last two rinses on all programmes except programme `A' and the wool programme `K', which increases automatically. Automatic wash features PULSE SPIN (Models W120FW and W120VW only) Helps reduce wear and tear on your wash items. Pulse spin is an automatic function where a long steady spin is followed by a 30 second burst at the maximum speed of your appliance to enable safer, more efficient water extraction. INTELLIGENT CARE Your appliance has an inbuilt feature to prevent it spinning with an unbalanced load, avoiding excessive vibration and prolonging the life of the appliance. 9 The Dispenser Drawer IMPORTANT INFORMATION: The Main Wash Indicator has been preset to dispense powder detergent only. If you wish to dispense liquid detergent see instructions for `Changing the Main Wash Indicator', next page. Release Button Main Wash Indicator (set to dispense `Powder'). Detergent (Pre-wash) Detergent (Main Wash) Fabric Conditioner CHOOSE A SUITABLE DETERGENT # # # Select `low suds' automatic washing powder, designed specifically for automatic washing machines or washer dryers. Follow manufacturer's dosage recommendations. Do not under dose, you will not achieve a clean wash. You will need up to 50% more detergent in hard water than in soft water areas to obtain the same wash results. 10 CHANGING THE MAIN WASH INDICATOR The Main Wash Indicator has been fitted, ready to dispense `Powder' detergent only. Dispensing Liquid Detergent Max. ­ 150ml. 50ml. 1 Pull drawer out until it reaches its stop. Fig 1 Fig 2 Refer to detergent manufacturer's instructions for dosage and pour liquid into the compartment (Fig 1). Note: The `Liquid Detergent' Main Wash Indicator features 3 lines which represent the dosage of liquid to be used (Fig 2). We recommend that you do not exceed the maximum limit of 150ml. WARNING Dispensing Powder Detergent G Do not dispense detergent tablets from the dispenser drawer. Refer to detergent manufacturer's instructions. 2 Press down on button to release drawer latch, remove drawer. To achieve optimum wash results we recommend that you use the detergent manufacturer's dispensing cup to dispense no more than 300 ml of powder (Fig 3). Fig 3 Dispensing Fabric Conditioner Pour fabric conditioner into compartment (Fig 4). We recommend that you do not exceed the maximum level indicated. indicator 3 Lift `Powder'rotate and out of slots, reposition for `Liquid' ensuring it is secure. Fig 4 Using a Dosing Ball To obtain claimed energy label wash performance for a 60°C cotton wash, dispense powder detergent in a dosing ball, placed in an upright position in the centre of the wash load (Fig 5). Fig 5 and 4 Re-locate drawerplace. push firmly back into 11 Care and Cleaning WARNING G Do not clean any part of your appliance with abrasive cleaners, scouring agents, acids, chlorine based bleach or metal polish as they may cause damage. CLEANING THE EXTERIOR REMOVING AND CLEANING THE DISPENSER DRAWER AND COMPARTMENTS Note: It is advisable to clean the dispenser drawer regularly. Use a damp cloth or silicon polish to clean the exterior surfaces of the appliance. CLEANING THE DOOR BOWL 1 Pull the dispenser drawer out until it reaches its stop. 2 Press button to release drawer latch and remove the dispenser drawer. Open the door, clean the internal surface of the door bowl and the rubber door seal with a damp soft cloth, dry thoroughly. A build up of soap powder and water hardness residue may result in water leaking from the door. 3 Clean and dry all parts of the dispenser drawer and internal fixed compartment thoroughly. 4 Re-locate drawer and push firmly back into place. Maintenance wash If you use liquid detergent regularly or wash at low temperatures, we recommend that you carry out a maintenance wash two or three times a year. To avoid build up of greasy deposits and water hardness residue, simply run the machine programme `C' with the usual amount of detergent, but without any clothes in the drum. 12 Regular Checks and Stain Removal Regular checks As with any major appliance, there are certain aspects which require regular attention. Listed below are a number of such key areas which you should check regularly. Before calling out a service engineer, ensure that the checks below have been carried out. Should the service engineer find nothing wrong with the machine, we regret that we will have to charge for the service call. Water leaks 1. 1 From back of machine ­ Are the inlet hoses securely tightened?­ Is the outlet hose correctly and securely positioned?1. 2 From front of machine ­ Check that there is no dirt or lint trapped between the lip of the rubber door seal and the door glass. ­ Check that the detergent dispenser is not prevented from closing tightly due to a build-up of detergent. Machine vibrating ­ Check that the transit bracket has been removed (see Installation Instructions and back of machine). Option buttons ­ Check after use that all the option buttons are in the Off position. OPTIONAL EXTRAS Longer fill hoses and drain hose extension kits are available where it is not possible to move the home plumbing closer to the machine. Carbon paper Chewing gum Glue Methylated spirits Methylated spirits Cold water or amyl acetate You will need a special adaptor if only a cold water supply is available. [. . . ] If contacted before 10am, we try to offer a service call the same day where required or the next working day. On request, your service call can be the first or last of the day with am or pm timings always available. We can also cater to meet your specific needs ie. A chargeable service is offered on the basis of payment on completion to our service engineer, who will issue a receipt. [. . . ]