User manual CRESTON MOBILE G QUICK START GUIDE

[. . . ] Locate the sample VT Pro-e project for the iPad at www. crestron. com/exampleprograms, and then download it to your computer. If desired, modify the project or create a new project, and then compile the project. NOTE: In VT Pro-e, names of the panel types are Crestron Mobile G and Crestron Mobile Pro G. NOTE: When used with the free Crestron Mobile G app, the VT Pro-e project is limited to about 10 pages; however, the limitation also depends on the complexity of the project (for example, number of buttons, graphics, and so on). [. . . ] From the Functions menu of the System Info tool, select Ethernet Addressing. The "Ethernet Addressing" window opens. NOTE: The router configuration screen shown above is a sample screen only. The screen that appears for the particular router you are configuring may differ from the sample screen shown. Since most ISPs block port 80, open up the HTTP port to the control system using a TCP port number other than 80. Use a number such as 8081 as used for the Webport (HTTP port) in the sample router configuration screen. Note that the port number you use maps to HTTP port number 80 on the control system in step 1c. Configure the iPad: NOTE: The form at www. crestron. com/crestronmobilesetup should be completed by an authorized Crestron installer if the customer is to configure the iPad. The instructions in this guide will then be e-mailed to the customer to provide assistance with the installation and startup of the Crestron app from the iPad. On the home screen, tap the Crestron app icon ( for Crestron Mobile G or for Crestron Mobile Pro G). When configuring the iPad for the first time, the screen appears empty. The system configuration screen opens. "Ethernet Addressing" Window g. Observe that the Port A: and Port B: fields are automatically populated with the default values of 41790 and 41791, respectively. If the first TCP/IP server port number in the SIMPL Windows program was changed from the default value of 41790 to another value, tap the Port A: field and replace 41790 with the assigned value. The next consecutive TCP/IP port number is automatically entered into the Port B: field. NOTE: If the firmware version of the control system is 4. 003. xxxx or later, the port numbers used for Port A and Port B must be the same; therefore, enter into the Port B: field the same value assigned in the Port A: field. Tap the Passcode: field, and then enter the passcode assigned in the SIMPL Windows program. The setup screen opens, listing the control system that has been added. Select the name/location of the control system, and then tap Connect. The Loading Configuration message appears in addition to a progress indicator. Sample System Setup Setup Screen (Empty) b. Enter a static IP address and related network information. Verify that the HTTP Port: field is set to the default value of 80. [. . . ] The default screen opens (shown above), allowing you to configure the Auto-reconnect and Check for Update functions as desired. To disable the Auto-reconnect function, the Check for Update function, or both, drag the corresponding slider from right to left. If both functions are disabled, the resulting screen appears as shown to the right. Auto-reconnect and Check for Update Set to OFF ) icon. Crestron, Crestron Mobile, Crestron Mobile Pro, and VT Pro-e are registered trademarks of Crestron Electronics, Inc. SystemBuilder and SIMPL are trademarks of Crestron Electronics, Inc. [. . . ]