User manual CRESTON QM-WCC-1

[. . . ] Crestron QM-FBCC-1 & QM-WCC-1 ® QuickMedia Computer Centers Operations & Installation Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance As of the date of manufacture, the QM-FBCC/WCC-1 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. [. . . ] Make sure all excess wire is completely inside the floor box or electrical box and not between the box and the QM-FBCC/WCC-1. For the QM-WCC-1, attach the wall plate using the screws that came with the wall plate. Remove the backing, which covers the adhesive, on the insert and attach the insert to the QM-FBCC/WCC-1, as shown in the illustrations on the following pages. Turn system power ON. 16 QuickMedia®: QM-FBCC/WCC-1 Operations & Installation Guide ­ DOC. 6716B Crestron QM-FBCC/WCC-1 QuickMedia® Computer Centers QM-FBCC-1 Installation (Two QM-FBCC-1s Shown) Insert, Black (4508384) Screws (2) #06-32 x 1" (2013235) Hubbell® SystemOne® Floor Box S1SP Plate (not supplied) QM-FBCC-1 Operations & Installation Guide ­ DOC. 6716B QuickMedia®: QM-FBCC/WCC-1 17 QuickMedia® Computer Centers QM-WCC-1 Installation Crestron QM-FBCC/WCC-1 1-Gang Wall Box (not supplied) QM-WCC-1 Screws (2) #06-32 x 1" (2013235) Wall Plate with Hardware (not supplied) Insert, Black (4508384) or Insert, White (4508383) 18 QuickMedia®: QM-FBCC/WCC-1 Operations & Installation Guide ­ DOC. 6716B Crestron QM-FBCC/WCC-1 QuickMedia® Computer Centers Hardware Hookup Make the necessary connections as called out in the illustration that follows this paragraph. Refer to "Network Wiring" on page 13 before attaching the 4-position terminal block connector. Apply power after all connections have been made. When making connections to the QM-FBCC/WCC-1, use Crestron power supplies for Crestron equipment. Hardware Connections for the QM-FBCC-1 (Front and Rear Views) AUDIO: Unbalanced Stereo Audio Input NET: To Control System And Other Cresnet Devices PC: VGA Video From PC QM: QuickMedia Port Carries Aaudio, Video, RGB And MIC Output Over CAT5 Hardware Connections for the QM-FBCC-1 (Side and Bottom Views) Ground QM: QuickMedia Port Carries Aaudio, Video, RGB And MIC Output Over CAT5 Operations & Installation Guide ­ DOC. 6716B QuickMedia®: QM-FBCC/WCC-1 19 QuickMedia® Computer Centers Crestron QM-FBCC/WCC-1 Hardware Connections for the QM-WCC-1 (Front and Rear Views) AUDIO: Unbalanced Stereo Audio Input NET: To Control System And Other Cresnet Devices PC: VGA Video From PC QM: QuickMedia Port Carries Aaudio, Video, RGB And MIC Output Over CAT5 Hardware Connections for the QM-WCC-1 (Side and Bottom Views) QM: QuickMedia Port Carries Aaudio, Video, RGB And MIC Output Over CAT5 Ground NOTE: Ensure the unit is properly grounded by connecting the ground wire to an earth ground (building steel). NOTE: For optimum performance, Crestron strongly recommends using CresCAT-QM cable, available from Crestron. Other high-quality/low skew CAT5e/CAT6 wiring may also be used with varying performance. NOTE: The maximum continuous current from equipment under any external load conditions shall not exceed a current limit that is suitable for the minimum wire gauge used in interconnecting cables. The ratings on the connecting unit's supply input should be considered to prevent overloading the wiring. 20 QuickMedia®: QM-FBCC/WCC-1 Operations & Installation Guide ­ DOC. 6716B Crestron QM-FBCC/WCC-1 QuickMedia® Computer Centers Programming Software Have a question or comment about Crestron software?Answers to frequently asked questions (FAQs) can be viewed in the Online Help section of the Crestron Web site. To post a question or view questions you have submitted to Crestron's True Blue Support, log in at http://support. crestron. com. First-time users will need to establish a user account. Earliest Version Software Requirements for the PC NOTE: Crestron recommends that you use the latest software to take advantage of the most recently released features. The latest software is available from the Crestron Web site (www. crestron. com/software). Crestron has developed an assortment of Windows-based software tools to develop a Cresnet system. [. . . ] or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee plus shipping costs on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. [. . . ]