User manual CRESTON TPMC-V12

[. . . ] Crestron TPMC-V12 & TPMC-V15 V-PanelTM Integrated 12" & 15" Touchpanels Operations Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance As of the date of manufacture, the TPMC-V12 and TPMC-V15 have been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. [. . . ] If no project has been loaded, the touchpanel will display an error message and return to the setup menu. Hardware Hookup Ventilation The TPMC-V12/15 should be used in a well-ventilated area. To prevent overheating, do not operate this product in an area that exceeds the environmental temperature range listed in the table of specifications. Connect the Device The TPMC-V12/15 can be connected using the included TPMC-V-IMCW interface module or (if the video inputs provided by the TPMC-V-IMCW are not needed) it can be connected directly to a Crestron control system (sold separately). Make the necessary connections as called out in the illustration that follows this paragraph. Apply power after all connections have been made. When making connections to the TPMC-V12/15, use Crestron power supplies for Crestron equipment. Hardware Connections for the TPMC-V12/15 Using TPMC-V-IMCW (TPMC-V15 Shown) 24 Y Z G: To TPMC-V-IMCW VIDEO / LAN: To TPMC-V-IMCW USB: To Mouse, Keyboard or Flash Drive MEMORY EXPANSION: For MMC Compatible Card Hardware Connections for the TPMC-V12/15 Without Using TPMC-V-IMCW (TPMC-V15 Shown) 24 Y Z G: To Cresnet Network or Power Supply VIDEO / LAN*: To LAN USB: To Mouse, Keyboard or Flash Drive MEMORY EXPANSION: For MMC Compatible Card * Negates video connectivity Operations Guide ­ DOC. 6940A V-PanelTM Integrated 12" & 15" Touchpanels: TPMC-V12 & TPMC-V15 · 47 V-PanelTM Integrated 12" & 15" Touchpanels Crestron TPMC-V12/V15 CAUTION: Do not apply excessive pressure to the touchscreen display during handling. Doing so can crack the screen and damage the touchpanel. NOTE: Direct connection of the TPMC-V12/15 to a Cresnet power source and Ethernet LAN, without the use of the TPMC-V-IMCW, negates video connectivity. NOTE: For wiring between the TPMC-V12 and interface module, use a TPMC-V-CBL-S Siamese Cable, CresCAT, CresCAT-D-HP, CresCAT-QM, DM-CBL or quality CAT5e/CAT6. CAT5e/6 requires an additional CRESNET or CRESNET-HP for Cresnet and power or else a single wire pair for power only. The maximum length for CRESCAT-D-HP, CAT5e/6 + CRESNET-HP or CAT5e/6 + 14 AWG power wire is 330 feet (100 meters) minus the length of any Ethernet cable connected to the LAN jack on the rear of the interface module. The maximum length for CresCAT, CresCAT-QM, DM-CBL, CAT5e/6 + CRESNET or CAT5e/6 + 18 AWG power wire is 155 feet (47 meters) minus the length of any additional Ethernet cable beyond 175 feet (53 meters). NOTE: For wiring between the TPMC-V15 and interface module, use a TPMC-V-CBL-S Siamese Cable, CresCAT, CresCAT-D-HP, CresCAT-QM, DM-CBL or quality CAT5e/CAT6. CAT5e/6 requires an additional CRESNET or CRESNET-HP for Cresnet and power or else a single wire pair for power only. The maximum length for CRESCAT-D-HP, CAT5e/6 + CRESNET-HP or CAT5e/6 + 14 AWG power wire is 330 feet (100 meters) minus the length of any Ethernet cable connected to the LAN jack on the rear of the interface module. The maximum length for CresCAT, CresCAT-QM, DM-CBL, CAT5e/6 + CRESNET or CAT5e/6 + 18 AWG power wire is 148 feet (45 meters) minus the length of any additional Ethernet cable beyond 182 feet (55 meters). NOTE: Be sure to set Cresnet to Disable when using Ethernet. Refer to "Cresnet" on page 31 for details. NOTE: When booting the TPMC-V12/15, the only USB devices supported are a keyboard or mouse. Having a USB drive or hub connected will interfere with proper booting of the touchpanel. NOTE: After inserting a USB device or MMC card, a "Found New Hardware" window may appear. [. . . ] The SOFTWARE may contain NetMeeting, Remote Assistance, and Remote Desktop technologies that enable the SOFTWARE or other applications installed on the Device to be used remotely between two or more computing devices, even if the SOFTWARE or application is installed on only one Device. You may use NetMeeting, Remote Assistance, and Remote Desktop with all Microsoft products; provided, however, use of these technologies with certain Microsoft products may require an additional license. For both Microsoft products and non-Microsoft products, you should consult the license agreement accompanying the applicable product or contact the applicable licensor to determine whether use of NetMeeting, Remote Assistance, or Remote Desktop is permitted without an additional license. You agree that MS, Microsoft Corporation, and their affiliates may collect and use technical information gathered in any manner as part of product support services related to the SOFTWARE. [. . . ]