User manual CRESTRON C2N-IIF AD

[. . . ] In the Essex and Discrete modes, all eight outputs are available. In the Matrix mode, only outputs 1 through 4 are available, while outputs 5 through 8 are reserved to enable four-by-four matrix switching. When high, the Essex keypad (if installed) backlight is activated for as long as the signal remains high (Essex mode only). Enables audio to be routed from the line level source to the speaker output, for as long as the signal remains high. [. . . ] This corresponds to a gain range from -80 dB to 20 dB. At system startup the value is initialized to 0%. PlayWAV1 through PlayWAV30 C2N-IIF Analog Input Signal Descriptions INPUT Audio_Vol (continued on next page) 4 · Intercom Interface: C2N-IIF Addendum #1 for DOC. 6235 Crestron C2N-IIF Intercom Interface C2N-IIF Analog Input Signal Descriptions (continued) INPUT Audio_Treble DESCRIPTION Adjusts audio treble from -14 dB to 14 dB (with 0 dB being flat) in 2 dB steps. Valid analog values range from -14d to 14d. Values greater than 14 dB will set the treble to 14 dB; values less than -14 dB will set the treble to -14 dB. +3 dB) will be rounded up to the next even value (e. g. -3 dB) will be rounded down to the next even value (e. g. At system startup the value is initialized to 0 dB. Adjusts audio bass from -14 dB to 14 dB (with 0 dB being flat) in 2 dB steps. Valid analog values range from -14d to 14d. Values greater than 14 dB will set the bass to 14 dB; values less than 14 dB will set the bass to -14 dB. +3 dB) will be rounded up to the next even value (e. g. -3 dB) will be rounded down to the next even value (e. g. At system startup the value is initialized to 0 dB. At system startup the value is initialized to 0%. Adjusts WAV treble from -14 dB to 14 dB (with 0 dB being flat) in 2 dB steps. Valid analog values range from -14d to 14d. Values greater than 14 dB will set the treble to 14 dB; values less than 14 dB will set the treble to -14 dB. +3 dB) will be rounded up to the next even value (e. g. -3 dB) will be rounded down to the next even value (e. g. [. . . ] If connected to a keypad, this means that the corresponding button is currently being pressed. In the Essex mode, when buttons 1 through 5 on the Essex keypad are pressed, the corresponding Input#_Press signal will briefly pulse. When discrete input 6 is closed to ground, the Input6_Press signal will remain high for as long as input 6 is closed to ground. In the Discrete mode, when inputs 1 through 6 are closed to ground, the corresponding Input#_Press signal will remain high for as long as the input is closed to ground. [. . . ]