User manual CRESTRON C2N-MMS

[. . . ] Crestron C2N-MMS Professional Multimedia Switch Operations Guide This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2005 Crestron Electronics, Inc. Crestron C2N-MMS Professional Multimedia Switch Contents Professional Multimedia Switch: C2N-MMS 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features and Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Refer to "Programming Software" on page 15 for more information. Cable Length and Suggested EQ/Boost Settings CABLE LENGTH 0 to 25 ft 25 to 50 ft 50 to 75 ft 75 to 100 ft More than 100 EQ1 Off On Off On On EQ2 Off Off On On On BOOST Off Off Off Off On NOTE: The sync output is not affected by peak and boost settings. NOTE: These settings are only suggested settings. Results may vary depending on the type of cable and installation methods used. The user should determine the settings for best results in specific installations. NOTE: Crestron has successfully tested 100-foot cable runs without loss of picture quality. Cable runs in excess of 100 feet may be subject to signal degradation as cable length increases over 100 feet. Operations Guide ­ DOC. 6374 Professional Multimedia Switch: C2N-MMS · 13 Professional Multimedia Switch Rack Mounting Crestron C2N-MMS WARNING: To prevent bodily injury when mounting or servicing this unit in a rack, take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety: · · The unit should be mounted at the bottom of the rack if it is the only unit in the rack. When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack. · If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. NOTE: If rack mounting is not required, rubber feet are provided for shelf placement or stacking. Apply the feet near the corner edges on the underside of the unit. NOTE: Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch circuit. Two "ears" are provided with the C2N-MMS so that the unit can be rack mounted. These ears must be installed prior to mounting. Complete the following procedure to attach the ears to the unit. The only tool required is a #2 Phillips screwdriver. There are 12 screws (#6-32 x 0. 375" LG) that secure the sides of the C2N-MMS top cover. Using a #2 Phillips screwdriver, remove the three screws closest to the front panel from one side of the unit. Refer to the diagram on the following page for a detailed view. Position a rack ear so that its mounting holes align with the holes vacated by the screws in step 1. Secure the ear to the unit with three screws from step 1, as shown in the illustration after this step. Ear Attachment for Rack Mounting 2. 3. 4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the opposite side. 14 · Professional Multimedia Switch: C2N-MMS Operations Guide ­ DOC. [. . . ] Authorized returns must be shipped freight prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N. J. , or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. [. . . ]