User manual CRESTRON CNSC-1A CNSCI-1A

[. . . ] CNSC-1A and CNSCI-1A Slide Control Unit CRESTRON ELECTRONICS, INC. i DOC 8010A CNSC-1A and CNSCI-1A SYNTAX: NET. ID < 10 to FE> : CNSC-1 <i1 to i6> = <signal name> < FWD > = < signal name > < REV > = < signal name > < FOC + > = < signal name > < FOC - > = < signal name > < PWR > = < signal name > \ Inputs \ Slide forward \ Slide reverse \ Focus in or Lock \ Focus out or Switch \ AC out DESCRIPTION: The CNSC-1 A and CNSCI-1 A Slide Control Units interface to a CRESNET II control system over the CRESNET II network. The CNSC-1 A (CNSCI-1 A) can be configured to provide control for Kodak Ektagraph, Kodak SA V, SIMDA and Electronic slide projectors. [. . . ] When the AC OUT switch on the front of the unit (SW in the preceding schematic) is pressed, the signal associated with < i6 > is momentarily driven high. Each slide control unit on the CRESNET II network requires the setting of an identity code (ID CODE). ID CODES are two-digit hexadecimal numbers, from 10 to FE. The ID CODE of the unit should be set to match the ID CODE specified in the NET . ID statement of the CRESNET II SIMPL-C program referencing the unit (see syntax above). To set an ID CODE, disconnect power and network connections and turn the unit so that the back faces you. Notice two miniature rotary switches identified as HI and LO. These 16-position hexadecimal switches can be set to 0 through F. Using a small screwdriver, rotate the arrow in the center of the switch marked HI point to the first (or most-significant) digit or letter of the specified ID CODE. Set the switch marked LO to the second (least-significant) digit or letter of the specified ID CODE. The 4-pin connector marked NET should be wired to the CRESNET II network. [. . . ] POWER FACTOR: 3. 0 watts REQUIRES: CRESNET II Workshop Version 4. 00 or later. CRESNET II Operating System SR30160. OPS or later. CRESTRON ELECTRONICS, INC. ii DOC 8010A CNSC-1A and CNSCI-1A CRESTRON ELECTRONICS, INC. iii DOC 8010A 9. 95 [. . . ]