User manual CRESTRON CNWM-LT9

[. . . ] The illumination of the LEDs, which are independently addressable, is programmed by SIMPL Windows. Physical Description Views of the CNWM-LT9 keypad are shown on the next page. Each keypad has nine buttons for system activations and nine LEDs for feedback indicators. The buttons and LEDs are arranged numerically from left to right, top to bottom. The keypad consists of three major assemblies. [. . . ] Separate the magnetic faceplate from the button assembly. Connect the Cresnet connector to the rear of the keypad system adapter. 4 · LiteTouch® Keypad: CNWM-LT9 Operations & Installation Guide - DOC. 5785 Crestron CNWM-LT9 4. LiteTouch® Keypad Make sure the LEDs are oriented above the keypad buttons and position the keypad into the electrical box. CAUTION: Excess wire that is pinched between the keypad and electrical box could shortcircuit. Make sure that all excess wire is completely inside the electrical box and not between the box and the keypad. Install the keypad into the electrical box. (Mounting screws are not provided. ) Make sure that the LED openings of the magnetic faceplate are aligned with the LEDs and install the faceplate. Turn Cresnet system power ON. Identity Code Every user interface within the Cresnet network requires a unique network identity code (NET ID). These codes are recognized by a two-digit hexadecimal number from 03 to FE. The NET ID of the keypad must match an ID code specified in the SIMPL Windows program. The NET ID of the CNWM-LT9 is factory set to 4D. The NET IDs of multiple keypads must all be unique and changed from a personal computer (PC) via VisionToolsTM Pro-e (VT Pro-e) or SIMPL Windows. NOTE: VT Pro-e is a Windows compatible software package for creating Crestron touchpanel screen designs. The method for changing the unit's NET ID is identical regardless of the software chosen. Attach one of the keypads to the control system (verify that the software is running) and complete the following steps to change the NET ID: 1. Disconnect all Cresnet devices from the control system, except for the keypad that needs to have its NET ID changed. Select Tools | Viewport to open the "Crestron Viewport" dialog box. The software checks the baud rate and then opens the "Set Network ID" dialog box. In the "Set Network ID" dialog box, highlight the keypad. The NET ID of the keypad appears in the box below the list. Use the scroll arrow to assign another NET ID. When the assigned NET ID appears, select the Set ID button to initiate the change. The software responds with a successful message to confirm the changed NET ID. [. . . ] CRESTRON shall not be liable to honor warranty terms if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures. Furthermore, this warranty does not cover any product that has had the serial number altered, defaced, or removed. This warranty shall be the sole and exclusive remedy to the purchaser. In no event shall CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages inclusive) arising from the sale or use of this equipment. [. . . ]