User manual CRESTRON CNXIRP

[. . . ] CRESTRON CNXIRP DESCRIPTION Cresnet Infrared Emitter The CNXIRP shown below, contains an infrared (IR) LED housed in a miniature, , mouse shaped, black, injection molded plastic shell. The CNXIRP shell emits IR control signals sent to it by a Crestron control system. [. . . ] INSTALLATION ATTACHING THE CNXIRP TO IR SENSOR WINDOWS (See A below) 1. Identify the clear adhesive layer on the flat bottom surface of the CNXIRP shell. Peel off the protective cover and affix the CNXIRP to the center of the IR sensor window on the controlled component's front panel. In some cases it may be difficult to find the location of the IR sensor on the component. Consult the owner's manual of the unit, or the manufacturer, for the exact IR window location. If the CNXIRP shell must be removed and repositioned for any reason, it may be necessary to replace the adhesive with a new piece of the twosided tape (supplied) to restore adhesion. Internal IR Emitter Low Output Side Clear adhesive layer. (Replace, if necessary, with a short piece of the two-sided tape supplied). Side View CNXIRP Shell A High Output Side B Adhesive Layer IR Mask CNXIRP Shell Mini-wire lead INSTALLING THE IR MASK (See B above) The IR mask (supplied) is designed to fit over the CNXIRP shell, (shown in B above), so that the sensor window of the controlled component is completely covered. It prevents unwanted external IR signals from passing through or leaking past it. It also prevents emitting IR from the CNXIRP shell from radiating backward into the IR sensors of other nearby components. Without removing the adhesive backing from the CNXIRP shell or IR mask, fit the two pieces together and accurately position them over the IR sensor window of the component to be controlled. If necessary, neatly trim the IR mask being sure that it overlaps the extremities of the component's IR sensor window. [. . . ] Note that the white-traced wire connects to the pin labeled S. A S GS IR Sensor Window Crestron CNXIRP Cresnet Infrared Emitter Installation Instructions Cresnet Infrared Emitter B GS C GS D GS E GS F G S5 INFRARED SERIAL RS 232 VCR Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888. CRESTRON / 201. 767. 3400 www. crestron. com Specifications subject to change without notice. [. . . ]