User manual CRESTRON CPC-CAMI

[. . . ] Crestron CPC-CAMI Pan/Tilt Camera Head with Control Interface Contents Pan/Tilt Camera Head with Control Interface: CPC-CAMI 1 Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Functional Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Physical Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Leading Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Confirm that the CPC-CAMI has a new NET ID code. Reconnect other network or modular devices that were disconnected in step 1. Preparation for Use Refer to the hookup diagram below. Other than connecting the correct jumper board first and making the power connection last, complete the connections in any order. NOTE: Before making connections to the NET port, review the latest revision of the Network Modular Cable Requirements (Doc. 5682) or the network interconnection drawing (Doc. Most 4-conductor phone cables are wired in a crisscross fashion and are not compatible with Crestron equipment. The wiring document can be obtained from the Downloads page (CABLES and MANUALS Libraries) of the Crestron website (www. crestron. com). Search for the MODULAR. PDF or CRESNET. PDF files, respectively. NOTE: To insure safe operation of the CPC-CAMI, all cables around the unit must be properly "dressed" so that the cables do not strike surrounding surfaces or equipment which would endanger safe system movement when in operation. Hookup Connections for CPC-CAMI Initialization There are no specific steps required to initialize the CPC-CAMI. The unit is ready four seconds after applying power. Operations Guide - DOC. 5726A Pan/Tilt Camera Head with Control Interface: CPC-CAMI · 11 Pan/Tilt Camera Head with Control Interface Limit Stop Adjustment Crestron CPC-CAMI Two locking screws are found on each rotating disk on the CPC-CAMI. Complete the following steps to properly set the limit stops. Loosen both pan (horizontal drive) and tilt (vertical drive) locking screws. Slowly rotate the camera/lens assembly to the desired left-pan limit. Slide a loosened locking screw until it engages the pan sensor; tighten the locking screw. Slowly rotate the camera/lens assembly to the desired right-pan limit. Slide the loosened locking screw until it engages the pan sensor; tighten the locking screw. Slowly rotate the camera/lens assembly to the desired up-tilt limit. Slide the loosened locking screw until it engages the tilt sensor; tighten the locking screw. Slowly rotate the camera/lens assembly to the desired down-tilt limit. Slide the loosened locking screw until it engages the tilt sensor; tighten the locking screw. 10. Verify the stop positions at slow speeds and then at full speed to ensure proper settings. Calibration Over time it may be necessary to recalibrate the CPC-CAMI to ensure proper operation. [. . . ] Authorized returns must be shipped freight prepaid to CRESTRON, Cresskill, N. J. , or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. [. . . ]