User manual CRESTRON ST-RMK

[. . . ] When the ST-RMK accommodates two modules, the extrusion and bracket are not used. Items 1 through 6 listed below are the supplied components of the ST-RMK. The tools required for installation of the ST-RMK are a #1 Phillips 1/4-inch hex bit, a 1/4-inch hex socket, and an inch-pound torque driver. [. . . ] 5. 6. Module (or ST-CP) Installation into ST-RMK Refer to the procedure below and complete the following steps for proper installation of a module (or ST-CP) into the ST-RMK. Place module into chassis so that front panel of the module is exposed, the two front rubber feet of the module fit into cutouts in the chassis, and the two rear rubber feet extend from the rear edge. As shown below, keep the module and chassis clean surface. 1 2. together and place upside down on a Module Installation 4 x4 (EXAMPLE MODULE) 3. Align screw holes in the chassis with holes in the module. Using a #1 Phillips 1/4-inch hex bit and an inch-pound torque driver, install four screws and tighten to 4-inch pounds (0. 45 newton-meters) to secure module. If installing another module, repeat this procedure. If not installing another module, return ST-RMK and module(s) to proper orientation and install into system rack. (Rack mounting screws are not supplied. ) 4. 2 · Rack Mount Kit: ST-RMK Installation Guide - DOC. 5664A Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange, or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. Products may be returned for credit, exchange, or service with a CRESTRON Return Merchandise Authorization (RMA) number. Authorized returns must be shipped freight prepaid to CRESTRON, Cresskill, N. J. , or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products returned with an RMA. Return freight charges following repair of items under warranty shall be paid by CRESTRON, shipping by standard ground carrier. In the event repairs are found to be non-warranty, return freight costs shall be paid by the purchaser. 2. 3. CRESTRON Limited Warranty CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in materials and workmanship under normal use for a period of three (3) years from the date of purchase from CRESTRON, with the following exceptions: disk drives and any other moving or rotating mechanical parts, pan/tilt heads and power supplies are covered for a period of one (1) year; touchscreen display and overlay components are covered for 90 days; batteries and incandescent lamps are not covered. [. . . ] Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. Windows is a registered trademark of Microsoft Corporation. [. . . ]