User manual CRESTRON ST-TUNE

[. . . ] This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Crestron ST-TUNE Integrated AM/FM/TV Tuner Contents Integrated AM/FM/TV Tuner: ST-TUNE Description Functional Description Physical Description Leading Specifications Setup Network Wiring Preparation for Use Identity Code Firmware Upgrade Programming with SIMPL Windows Configure ST-TUNE Program ST-TUNE and STI-TUNE Symbols Basic Example Program Advanced Example Program Problem Solving Troubleshooting Further Inquiries Future Updates Future Firmware Upgrades Appendix 1: High-Gain AM Antenna Materials Required Fabrication Instructions Appendix 2: STI-TUNE TV Receptions Appendix 3: Upgrade Firmware Version Prior to 2. 17 Return and Warranty Policies Merchandise Returns / Repair Service CRESTRON Limited Warranty 1 1 1 2 6 8 8 9 10 11 14 15 15 20 21 22 22 24 24 24 25 25 25 27 28 35 35 35 Operations Guide - DOC. 5833A Contents · i Crestron ST-TUNE Integrated AM/FM/TV Tuner Integrated AM/FM/TV Tuner: ST-TUNE Description Functional Description The ST-TUNE is a Crestron remote control network (herein referred to as the Cresnet system) optimized high-performance AM/FM/WX (Weather radio) and television (TV) tuner. The ST-TUNE provides professional audio that connects directly to and is accessed by a Cresnet system. [. . . ] This signal cycles through the AM, FM, WX, and TV bands. The band Func is selected on the rising edge. AM, FM, WX, Each of these signals selects one of the four bands directly. The band is selected on the rising edge. TV This signal performs the same function as pressing the MODE button Mode on the front panel. (The MODE function cycles through PRE, TUNE, SRCH tuning modes. ) The MODE is selected on the rising edge. Each of these signals selects one of the three modes directly. The Pre, Tune, function is selected on the rising edge. These will change the function Srch of the UP and DOWN buttons. (Refer to Pre-F, Tune-F, and Srch-F in the next table for related information. ) NOTE: In PRE mode, no function is performed, PRE mode must be programmed in SIMPL (typically this would be logic to recall stations; see the ST-TUNEB. ZIP program examples). This signal (not active in AM mode) performs the same function as Mono pressing the MONO button on the front panel. This function toggles on each rising edge. These signals select one of the mono modes directly. The function is Mono-On, selected on the rising edge. Mono-Off ST-TUNE ONLY - These signals turns SAP reception on or off during SAP-On, TV mode only. This mode is selected on the rising edge. SAP-Off Sense-High, These signals directly adjust the sensitivity of tuning. The sensitivity is selected on the rising edge. NOTE: SENSE-HIGH allows the unit Sense-Low to recognize weaker stations during the search mode. (Refer to SigStrength in the next table for related information. ) Disable-Lcl- When this signal is high, the local functionality of the front panel buttons is disabled. (The button presses are still reported into the Btns program on the output of the symbol. ) Off-Air, STD, ST-TUNE ONLY - These are four modes of TV reception. In each mode, the channels map to different frequencies. [. . . ] Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number, and return address. Products may be returned for credit, exchange, or service with a CRESTRON Return Merchandise Authorization (RMA) number. Authorized returns must be shipped freight prepaid to CRESTRON, Cresskill, N. J. , or its authorized subsidiaries, with RMA number clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA number shall be subject to refusal. [. . . ]