User manual CRESTRON TPS-5000 TPS-6000

[. . . ] NOTE: If the angle of the touchscreen needs to be adjusted, refer to the latest revision of the TPS-5000 or TPS-6000 Operations Guide (Doc. 5863 or 5864, respectively) for instructions of how to use the touchpanel position lock buttons. The latest version of the appropriate Operations Guide can be obtained from the Downloads page (MANUAL Library) of the Crestron website (www. crestron. com). New users are required to register to obtain access to the FTP site. [. . . ] CAUTION: Do not allow Bix stripper to come into contact with internal components, cabling, or other plastic material of the touchpanel. Doing so can damage the material and may prevent the touchpanel from operating normally. Use the nylon brush and dab a generous coat of the Bix Stripper onto an interior area of the touchpanel base plate as defined in the diagram on the next page. Field Service Guide - DOC. 5956 Field Service for IsysTM TouchPanel: FSKTPS-5000/6000 · 3 IsysTM Touchpanels Remove Paint from Defined Area Crestron FSKTPS-5000/6000 APPROX. DEPTH 2 INCHES REMOVE PAINT FROM THIS INTERIOR AREA. 15. Check for dry spots; apply stripper to those areas again. Wait a few minutes while the stripper lifts (bubbles) the paint from the metal surface. Use a cotton swab or cloth (non-abrasive) to wipe away the loose paint from the interior face of the base plate. Repeat steps 14 through 17 if any paint remains in the defined area. Remove the masking tape from the exterior face of the base plate and carefully remove excess stripper and loose paint caught in the holes. Re-insert the two rubber feet into the appropriate holes of the base plate. 4 · Field Service for IsysTM TouchPanel: FSKTPS-5000/6000 Field Service Guide - DOC. 5956 Crestron FSKTPS-5000/6000 Installation of New Nose IsysTM Touchpanels LEFT SPEAKER CONNECTOR RIGHT SPEAKER CONNECTOR RETURN FEET ONLY IF REMOVED. 21. Attach the three cables from the new nose to the proper connectors on the panel. For example, the left speaker wire (marked L) from the new nose connects to the connector on the panel marked 'left speaker connector' in the diagram, above. Carefully slide the new nose onto the panel. Hold the nose in place and position the touchpanel facedown onto a padded surface to prevent scratching of the screen. Re-install the four base cover screws to finger-tight then, using a Philips screwdriver, tighten an additional 1/8-turn. Re-connect all cables attached to the touchpanel rear panel ports and apply power. Further Inquiries If after reviewing this Field Service Guide, you cannot locate specific information or have questions, please take advantage of Crestron's award winning customer service team by calling: · · · · · · In the US and Canada, call Crestron's corporate headquarters at 1-888-CRESTRON [1-888-273-7876] or 1-201-767-3400. In Europe, call Crestron International at +32-15-50-99-50. In Asia, call Crestron Asia at +852-2341-016. In Latin America, call Crestron Latin America at +525-260-4336. In Australia, call Soundcorp at +613-9488-1555. [. . . ] CRESTRON makes no other warranties nor authorizes any other party to offer any warranty, expressed or implied, including warranties of merchantability for this product. This warranty statement supersedes all previous warranties. Trademark Information All brand names, product names, and trademarks are the sole property of their respective owners. Windows is a registered trademark of Microsoft Corporation. [. . . ]