User manual CRESTRON UG CLS-C6 CLS-C6M CLSI-C6 CLSI-C6M

[. . . ] In Shades mode, they indicate the shade position for each of the shade groups. In Standard mode, these buttons are used to select/recall scenes. In Lights mode, they are used to make temporary adjustments to the six lighting loads. In Shades mode they are used to make temporary adjustments to the six shade groups. [. . . ] Shades mode: this mode is used to manually control shade groups. The following descriptions do not include additional functionality made possible by dealer programming. Those functions are beyond the scope of this guide. User Guide - DOC. 6395A iLuxTM Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M · 3 iLuxTM Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M Standard Mode By default, the six function buttons recall scenes 1 - 6. As a scene is recalled, the lights fade (change from one level to another) in a specified time, and any shades in the scene go to their specified levels. The ON and OFF buttons recall the On and Off scenes, respectively. By default, the On scene will set all lights to full on. The Off scene will always set all lights to full off. While fading, the LED for the selected scene recall button blinks, and then stays on when fade is complete; the two-digit display shows the time remaining; If you press the selected scene recall button again before fade is complete, the lights immediately go to their assigned levels and the LED turns solid. The six bargraphs always show the current level of each lighting load. When all lights are off, the LEDs for all function buttons glow dimly to make it easy to locate the panel in the dark. The Up/Down button acts as a lights master, adjusting the level of all dimmable lighting loads simultaneously. Pressing the top of the button raises the lights; pressing the bottom of the button lowers them. You can also select functions using an optional remote keypad or IR remote control. Lights Mode Lights mode lets you manually adjust any of the six lighting loads. To enter Lights mode, press the Lights button. The LED will light, and the six function buttons can now be used to adjust the six lighting loads. · · · Press the right side of the function buttons to raise the lights; press the left side to lower the lights. The six bargraphs show the current level of each lighting load. While a particular lighting load is being adjusted, the two-digit display shows its level. ("oF" indicates fully off; "on" indicates fully on; "1" ­ "99" indicate percent of the full on level. ) Press the center of a function button to check light level without adjusting. The Up/Down button acts as an all lights master in this mode. Press the top of the button to raise the lights; press the bottom of the button to lower the lights. · The ON and OFF buttons operate normally while in Lights mode. To exit Lights mode, press the Lights button again, or press Cancel. [. . . ] and the scene number; the Lights LED will be lit, and the Save and Cancel LEDs will flash. Use the six function buttons to adjust the levels of the lighting loads for that scene. Press the left side of the buttons to lower the lighting loads; press the right side of the buttons to raise the lighting loads. If you would like a certain lighting load to be unaffected by that scene recall, press and hold the center of the button (so both sides make contact) for three seconds. [. . . ]