User manual CROWN MA-5000I BROCHURE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CROWN MA-5000I. We hope that this CROWN MA-5000I user guide will be useful to you.

Lastmanuals help download the user guide CROWN MA-5000I.


Mode d'emploi CROWN MA-5000I
Download
Manual abstract: user guide CROWN MA-5000IBROCHURE

Detailed instructions for use are in the User's Guide.

[. . . ] Total Harmonic Distortion (THD) Plus Noise (at full rated power): < 0. 35%, 20 Hz to 20 kHz. Intermodulation Distortion (IMD) (60 Hz and 7 kHz at 4:1, from full rated output to ­30 dB): < 0. 35%. Damping Factor (20 Hz to 100 Hz at 8 ohms): > 5000. Crosstalk (below rated power, 20 Hz to 1 kHz): > 80 dB. [. . . ] Data Indicator: Yellow LED on front panel indicates network data activity. Data indicator flashes only when the amplifier is polled for data, or is polled to see whether it is online Power Switch: Push-on/push-off switch with built-in green AC mains present indicator. Volume Control: Precision detented attenuator with 31 steps, press-and-hold mute function. Volume Control LED Ring: A ring of green LEDs around each volume control show the position of the control. Entire ring flashes when channel is muted. Can be converted to be a level meter. Network Connector: This Neutrik® Ethercon connector accepts an RJ-45 connector for TCP/IQ or HiQnetTM networking. Next to the connector is a yellow LINK ACT indicator that shows network activity, and a green 100Mb indicator that shows a 100Mb network connection. Data Indicator: Yellow LED on back panel indicates network data activity. Data indicator flashes only when the amplifier is polled for data, or is polled to see whether it is online. Preset Indicator: Green/yellow LED flashes to signal the number of the current preset. LED is green if current preset is active, or is yellow if current preset is modified. Input Sensitivity Switch: Three-position switch providing 1. 4V, 32 dB, and 26 dB settings for both channels. Firmware/Software Firmware can be updated at www. crownaudio. com > Support > Downloads. Software features: User Presets, Clip Event Monitor, Input Signal Level Monitor, Output Signal Level Monitor, Thermal Headroom Level Monitor, Power/ Standby Control, Signal Mute, Polarity Inverter, Input Signal Fader, Dynamic Gain Monitors (Ghost Faders), Amplifier Information, User and Channel Labels, Amplifier Mode, Amplifier Output Mode, Line Voltage Monitor, Error Reporting, Auto Standby, Input Signal Compressor/Limiter, Peak Voltage Limiter, Average Power Limiter, Clip Eliminator, Thermal Limiter, Limiter Tie, Load Supervision. Back Panel Controls, Indicators and Connectors Power Cord Connector: Detachable 20 amp IEC inlet. Cord locks with supplied cord retention clip. Voltage range is indicated above IEC inlet. Reset Switch/Circuit Breaker: If the current draw of the amplifier exceeds safe limits, this breaker automatically disconnects the power supply from the AC mains. Output Connectors: Two high-current, 50A Neutrik® Speakon® NL4MLP (mates with NL4FC or NL4), one per channel. Ch 1 Speakon® is wired with Ch 1 and Ch 2 outputs for use with single 4-conductor cable. Two pairs of high-current, 60A color-coded 5-way binding posts (for banana plugs, spade lugs or bare wire). Analog Input Connectors: A 3-pin female XLR connector for each channel. [. . . ] For customers outside of the USA, please contact your authorized Crown distributor for warranty information or call 574-294-8200. Crown International 1718 W. Elkhart, IN 46517-9439 TEL: 574-294-8200 FAX: 574-294-8FAX www. crownaudio. com Specifications subject to change without prior notice. Latest information available at www. crownaudio. com. Crown, Macro-Tech and Crown Audio are registered trademarks; HiQnet is a trademark of Crown International. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CROWN MA-5000I

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CROWN MA-5000I will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag