User manual CULLIGAN AC-30L PLUS

[. . . ] Culligan® Good Water Machine® Drinking Water System Owners Guide NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult your licensed plumber for installation of this system. The use of piercing valves is not permitted in Massachusetts. Check with your public works department for applicable local plumbing and sanitation codes. Follow your local codes if they differ from the standards used in this manual. [. . . ] Locate the system's supply valve and turn off the system's water supply. Using the graduated cylinder, add 5 ml (about 1 teaspoon) of bleach to the 1-gallon container. Open the dispenser faucet and fill with one gallon of product water. If there is not enough RO water, fill the container the rest of the way with soft water. Notice: If any RO water remains after filling the container, you may want to fill a pitcher with the drinking water as it will take several hours for the system to refill after servicing. In any case, leave the faucet open until the storage tank is empty and then, close the faucet. Connect the tubing ends together with the tubing connector. Lift the filter assembly from the mounting bracket and place it in the plastic pan to catch any dripping water. Using the flat-blade screwdriver, pull the u-clips from all three housings. Insert the u-clip into the two square holes at the bottom rear of the manifold and push up to release the filter housings. Remove the housings with a downward twisting pull. Remove the particle filter cartridge and the activated carbon cartridge and discard. If the RO membrane filter will be reused, clean the outside with a wet paper towel and place the membrane filter in a clean, unused plastic bag. Wet some paper towels with the diluted bleach solution. Clean the inside of the housings and the underside of the manifold with the paper towels. Sanitizing the Storage Tank and Faucet 1. Add 15 ml (about one tablespoon) of bleach to the particle filter housing (#1, Figure 3). Replace all three housings on the manifold and insert the u-clips. Notice: The weight of the storage tank will increase by 8 to 16 pounds. Turn on the supply valve and fill the storage tank with 1 to 2 gallons of water. Wait ten minutes before opening the faucet and draining the storage tank. Do not rinse any remaining solution from the tank. Notice: During this time, proceed to the "Sanitizing the Manifold Assembly" section. [. . . ] Influent chlorine should not exceed 3 mg/L. A softener is strongly recommended for water over 10 gpg. Performance Data Sheet (cont. ) 3 Application Guidelines The Good Water Machine is designed for use on potable water supplies meeting the guidelines outlined in Table 1. The system should be installed on your home's cold water line. The flushing stream should discharge through an approved siphon break as illustrated in Figure 1. [. . . ]