User manual CULLIGAN MEDALLIST PLUS SERIE 45

[. . . ] Culligan Medallist Series® Automatic Water Conditioner Owners Guide Thank You And Welcome To Your New World Of Better Living With Culligan Water. The Culligan Medallist Plus Series® 30, 45 and 60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnesium) as verified and substantiated by test data. For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult your licensed plumber for installation of this system. This system and its installation must comply with state and local regulations. Hardness sample kits are available through your local Culligan Dealer. [. . . ] 12 or 24 Hour Clock Press the "STATUS" key. The display will blink "dIP6" for 3 seconds and then show the current status. Toggle between "12 Hr" (12 hour clock) and "24 Hr" (24 hour clock) with the "+" or "-" key. 3/4" or 1" Meter Press the "STATUS" key. The display will blink "dIP7" for 3 seconds and then show the current status. Toggle between "3-4" and "InCH" with the "+" or "-" key. Note: The 3/4" meter setting is to be used with the 8" Medallist Series softener. The 1" meter setting is for the Medallist Plus series softener. 6. 7. 3-4 18 Setting the Microprocessor The microprocessor senses when it is installed as a Soft-Minder® control. Adding or removing any connection to the board will automatically reset the microprocessor to the factory settings. Step 1 ­ Programming Time of Day Press the "STATUS" key. The display will blink "tod" for 3 seconds and then change to time of day with the "minutes" digits blinking. Adjust the "minutes" digits with the "+" or "-" keys. Press the "REGEN" key to blink the "hours" digits. Adjust the "hours" digits with the "+" or "-" keys. PM Press the "REGEN" key to cycle back to "minutes" Note: The "hours" setting scrolls through 1-12 and 1-12 PM. Make sure the proper AM or PM indicator is shown when setting the time (AM is not displayed). Programming (cont. ) 12:00 2:00 10 10 Step 2 ­ Programming Regeneration Time Press the "Status" key after setting the time of day. The display will blink "tor" for 3 seconds and then change to the time setting with the "ones" digit blinking. Adjust regeneration time as time of day above. Note: This option will not show if the "dIP 2" option is set to immediate Step 3 ­ Programming Salt Dosage Press the "Status" key after programming regeneration time. The display will blink "SLtP" if set to English or "SLtG" if set to Metric for 3 seconds and then display the salt dosage. Adjust the setting with the "+" or "-" key (3-24 lbs. ) (1-10 kgs. ) Note: This option will not show if the control is set to Filter mode. Step 4 ­ Programming Backwash Time Press the "Status" key after programming salt dosage. [. . . ] Any part found defective within the terms of this warranty will be repaired or replaced by the dealer. You pay only freight from our factory and local dealer charges. We are not responsible for damage caused by accident, fire, flood, freezing, Act of God, misuse, misapplication, neglect, oxidizing agents (such as chlorine, ozone, chloramines and other related components), alteration, installation or operation contrary to our printed instructions, or by the use of accessories or components which do not meet Culligan specifications, is not covered by this warranty. Refer to the specifications section in the Installation and Operating manual for application parameters. [. . . ]