User manual CULLIGAN MEDALLIST AUTOMATIC WATER CONDITIONER

[. . . ] The Culligan Medallist Series® 8 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnisium) and barium/radium as verified and substantiated by test data. The Culligan Medallist Plus Series® 30, 45 and 60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the effective reduction of hardness (calcium and magnesium) and barium/radium as verified and substantiated by test data. The Culligan Medallist Plus Series® 30, 45 and 60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 61 for material requirements. for installations in Massachusetts , Massachusetts Plumbing Code 248 CMR shall be adhered to. [. . . ] Note: If setnipple must extend no more than 1 inch abovebackup, the unit will initiate regeneration at 12:00 AM. Disassembly while under water pressure can result in flooding. Cover or accessing any internal control parts. ensure that all faucets at the installation site are closed. Direct the drain line discharge into a bucket where flow can be observed. plug the transformer into a 120 Volt , 60 Hz , single-phase receptacle. Wait for the control to energize the motor and home itself. Initiate an immediate regeneration to move the control into the backwash position. refer to the section on manual cycling for information on cycling the control through its positions. When in the backwash position, slowly shift the bypass to the soft water position until water flows. Allow the tank to fill slowly until water flows from the drain line. when flow to drain is established , open the bypass fully. Watch the drain line discharge for signs of resin. if signs of resin particles appear , reduce the flow. Increase the flow again when resin no longer appears in the discharge. When the unit is filled with water, return the timer to the service position and proceed with setting the microprocessor. Note: Unplugging the Culligan® Medallist Series water softener will not affect any of the control settings. If longer time storage is necessary, a battery backup is available. Salt is the Inside Textmineral used to "recharge" your water conditioner. A brine solution is automatically made up in the bottom of the salt storage container, the Cullex® resin beads in the tall, thin tank are flushed with brine solution as a step in the recharging process. Your Culligan Water Conditioner has been carefully designed to get the greatest amount of softening capacity from the salt it uses. Here is some pertinent information about salt usage, types and service. [. . . ] You pay only freight from our factory and local dealer charges. We are not responsible for damage caused by accident, fire, flood, freezing, Act of God, misuse, misapplication, neglect, oxidizing agents (such as chlorine, ozone, chloramines and other related components), alteration, installation or operation contrary to our printed instructions, or by the use of accessories or components which do not meet Culligan specifications, is not covered by this warranty. refer to the specifications section in the Installation and Operating manual for application parameters. Our product performance specifications are furnished with each water conditioning unit. [. . . ]