User manual CURTIS FRW120

[. . . ] USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. To prevent direct exposure to the laser beam, do not try to open the enclosure. Visible laser radiation when open and interlocks defeated. Refer to the identification/rating label located on the back panel of your product for its proper operating voltage. [. . . ] Antenna: This feature sets the TV tuner to an Air antenna or a Cable antenna. Please use Air mode when using an over-the-air antenna; use Cable mode for a cable hookup. Press to select between the two options. Auto Program: This feature will setup the Active channel list for the user. The list will include only the channels with a signal detected. Press to begin and to stop the process. Tuner Channel Add/Erase Antenna Auto Program 2 Add Air Stop Start Timer Menu Time This feature allows you to set the clock on the TV. On Time This feature allows you to preset a time when the TV set will turn on. On Channel This feature allows you to preset the channel on display when the On Time is activated. Off Time This feature allows you to preset a time when the TV set will turn off. Timer Timer can be set to Once or Always. Timer Time On Time On Channel Off Time Timer --:---:---:-Once System Menu Language This feature allows you to pick a language used for the on screen display (OSD). Press to select the language of your choice - English (Eng. ), French (Fra. ) or Spanish (Esp. ). With the Pass Code function ON, you can also change the Pass Code. Press to highlight Pass Code, then enter the new Pass Code using the numeric keypad. Note: Pass Code Menu Pass Code Control Pass Code 6688 The factory pre-set password is 6688. The initial password will be replaced when the new one is used. Please contact the service centre in case you forget the password. Enter Pass Code - - - - 13 Instruction ManualManual FUNCTIONS & FEATURES (continued) Useful Remote Control Features DISPLAY This key allows you to display the current information of the TV screen on the upper right hand corner of the screen. (channel, antenna mode, time, video, etc. ) SCAN Press the SCAN key twice, and the TV will begin to scan through all active channels. To stop the Scan, pressing any key can interrupt scanning. Please note that Scan will only work in Antenna mode. PICTURE Your TV has factory preset picture modes that allow you to optimize your TV viewing. To activate these picture modes, press this key, and you can choose among User, Normal, Movie and Sports. RECALL This key will allow you to return to the last channel you were viewing. [. . . ] Displaying the setup menu screen The SETUP MENU screen asks you to select a setting category from General Setup, Speaker Setup, Audio Setup, and Preferences. The selected category will provide you the setting details on-screen. Press / to select category (highlight), then press ENTER. Press SETUP to normal playback. General --General Setup Page-Tv Display Ps Angle Mark On Osd Lang Eng Spdif Output Raw Captions Off Screen Saver On On Off On Off Spdif Off Spdif/Raw Spdif/Pcm English French Spanish On Off Normal /Ps Normal /Lb Wide Audio --Speaker Setup Page-Downmix Stereo Lt/Rt Stereo Dolby --Dolby Digital Setup-Dual Mono Stereo Dynamic Stereo L-Mono R-Mono Mix-Mono FULL 3/4 1/2 1/4 OFF Video --Video Setup Sharpness Brightness Contrast Page-Low 00 00 Preference --Preference Audio Subtitle Disc Menu Parental Password Default English French Spanish Chinese Japanese Korean Page-Eng Off Eng ADULT High Medium Low Reset English French Spanish Chinese Japanese Korean Off -16~ +16 -20~ +20 English French Spanish Chinese Japanese Korean 1 KID SAFE 2G 3 PG 4 PG-13 5 PG R 6R 7 NC-17 8 ADULT Change Old Password New Password Comfirm PWD OK Notes: · Preset password is 1225. [. . . ]