User manual CURTIS MWC495

[. . . ] Plug the other end of the handset coiled cord into the base. Tip: If your telephone outlet is not modular, contact your telephone company for assistance. Wall mounting the telephone. The unit may be wall mounted either on a telephone wall plate or with two screws (not included). If using screws, insert them into the wall leaving 3/16'' of each screw extending out from the wall. When installing screws into plasterboard walls, use wall anchors(not included) to ensure that the screws remain secure. 1. [. . . ] After several seconds the call timer will begin keeping track of the elapsed time for the phone call. To hang up, place the handset back in the base. Last number redial 1. To redial the last number called, pick up the handset. When you hear the dial tone, press the [Redial] key. After several seconds the call timer will begin keeping track of the elapsed time for the phone call. To hang up, place the handset back in the base. Receiving calls 1. When there is an incoming call, ringing is heard. If you are subscribed to caller ID service, the caller information is shown after the first ring. 2. To answer the call, pick up the handset and begin to speak. After several seconds the call timer will begin keeping track of the elapsed time for the phone call. When you have finished your call, place the handset back in the base to hang up. Review the incoming call messages (up to 80 sets) Press Review Left Up [ ] Key or Review Right Down[ ] Key repeatedly to review the last sets of incoming call message. To regulate the loudness of the radio, rotate the CONTROL clockwise to desired position. If you wish to be aw3akened preset time by the "Buzzer" rotate the CONTROL counter-clockwise until a "click sound is heard. press this button simultaneously with the HOUR or MINUTE button to set the desired time. Use these buttons to set the time, while pressing the Alarm set button or Sleep button. slide the switch to turn radio "ON", "OFF" or to "AUTO" position. When the switch is in the "AUTO" position, it will permit automatic turning "ON" and "OFF" of the radio according to the sleep and alarm settings. Press this button simultaneously with the HOPUR or MINUTE button to set the desired wakeup time. Press this button to display the number of minutes (59 or less) where the radio will sound for 59 minutes and will automatically turn off after then. When you are awakened by music or buzzer but wish to sleep a few to sleep a few minutes more, simply touch the "snooze" button and it will shut off the music or buzzer for approximately 5 to 10 minutes before the music or buzzer sounds again. This can be repeated several times. USING THE RADIO 1. Adjust the Radio On/Off/Auto switch to the "ON "Position. [. . . ] You will be awakened at the pre-selected alarm time by the buzzer tone. To turn the Buzzer off, slide the AUTO/OFF/ON switch to the "OFF" position or press ALARM SET/OFF Button. ALARM OFF Slide the AUTO/OFF/ON switch to "OFF" position if you wish to turn off the radio or buzzer after the radio or buzzer has sounded in the Wake to Radio or Wake to Buzzer operation. The alarm will not sound again until the next day unless you switch back to "AUTO" position or use alarm button to shut off alarm, then the radio or buzzer will automatically sound again in 24 hours at the same alarm setting. SLEEP CONTROL Step 1 --- Turn the AUTO/OFF/ON switch on the "AUTO" or "OFF" position. Step 2--- Press the SLEEP button to display the sleep time. [. . . ]