User manual CURTIS MWC612

[. . . ] For products intended to operate from battery power, or other sources, refer to the operation instructions. 8. Grounding Polarization - This product may be equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way this is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. [. . . ] d) If the product does not operate when used according to the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may interfere with the product's normal operation. e) If the product has been dropped or damaged in any way. f) When the product exhibits a distinct change in performance-this indicates a need for service. Servicing - The user should not attempt to service the product beyond that described in the operating instruction. All servicing should be referred to qualified service personnel. Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching power lines or circuits as contact with them might be fatal. 18. Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static. Section 810 of the National Electrical Code ANSI/NEFA 70 provides information with respect to proper grounding of the mast and supporting structure, grounding conductress, location of antenna-discharge unit, size of grounding electrodes, and requirements for the grounding electrode (see figure). Cleaning - Unplug this product from the wall outlet before cleaning. Note: Repeat the above steps if you run past the correct time. A glowing dot appears in the lower left hand corner of the display, indicating that the time shown is PM time. TO SET THE ALARM Step 1 Press the Alarm set button to check the alarm time. Step 2 Press the Alarm set button together with the HOUR or MINUTE button to adjust the alarm time, paying close attention on the PM indicator. NOTE: A glowing dot appears in the lower left hand corner of the display indicating that the alarm has been set to operate. TO PLAY THE RADIO Step 1 Slide the AUTO/OFF/ON switch to the "ON" position. Step 2 Slide AM/FM band switch to desired band. Step 3 Select the desired radio station by turning the Tuning knob. Step 4 Adjust the Volume to the desired listening level. TO WAKE TO RADIO Step 1 Set the alarm as previously instructed. Step 2 Turn the radio on and select the desired radio station and volume setting as previously instructed. [. . . ] The radio will turn on automatically and will turn itself off when the pre-set time has passed. NOTE: The maximum sleep time is 1 hour and 59 minutes. The radio will be switched off automatically when the sleep time expires. To turn the radio off before expiration of sleeping time, simply press the "SNOOZE BUTTON". [. . . ]