User manual CURTIS RCD309

[. . . ] RCD909 INSTRUCTION MANUAL WARNING WARNING To prevent fire or shock hazard, do not use this plug with an extension cord, receptacle other outlet unless the blades can be fully inserted to present blade exposure. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. The lightning flash with arrowhead Symbol, within an equilateral Triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance(servicing)instructions in the literature accompanying the Appliance. IMPORTANT SAFETY INSTRUCTIONS 1 2 3 4 5 6 7 8 9 Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ] For AM reception the signals are picked up through the external frame antenna, you may have to move the frame antenna to obtain the best reception. HANDLING COMPACT DISCS To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. Fingerprints and dust should be carefully wiped off the discs forward to the left of unit with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in a straight line from the inside to the outside of the disc. Small dust particles and light stains will have absolutely no effect on reproduction quality. Never use chemicals such as record sprays antistatic sprays, benzene, or thinners to clean compact discs. These chemicals can irreparably damage the discs surface. Discs should be returned to their cases after use. This avoids serious scratches that could cause the Laser pickup to skip Do not expose discs to direct sunlight, high humidity 5 or high temperatures for extended periods. Long exposure to high temperatures can warp the disc. Do not stick paper or write anything with a ballpoint pen in the label side of the disc. LOADING AND UNLOADING COMPACT DISCS Press the Power button to turn the unit on. Select the CD function by pressing the CD button. CD plays automatically, when you inject the CD in the unit under CD mode. Eject the disk at any time by first pressing the stop button and then pressing the EJECT button. When the Disc exit , if you do not pick up it within 10 second , it will go in and reloading automatically. CAUTION Do not put anything except a compact disc into the compartment. Foreign objects can damage the mechanism. Never place more than one disc into the disc compartment at any time. If the disc is correctly loaded, the total number of tracks on the disc will be displayed. Notes: After the disc compartment is fully closed, the disc information may not appear on the display. This means that the disc is improperly loaded (most likely it is upside down). To check, open the disc compartment again and reload the disc. [. . . ] Press "Menu" three times , "TS" show on the display , adjust the treble level by pressing "Volume/Up" or "Volume/Down". ENTERING A PRAGRAM It is possible to program the tracks you wish to play in a sequence of your choice, it is not possible to enter programs during disc play. Press the Stop/ Band button first, and then follow the instructions below. The information will be shown on the display. [. . . ]