User manual CURTIS SRCD4721

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. [. . . ] NOTE: If you select either the FM or FM Stereo bands, be sure to raise the FM rod antenna and extend it to its full length. 23 24 25 26 ST. /MO/ REPEAT PRESET -UP 28 STOP 27 BAND 4 1 5 FM 2 6 MHz PLL REMOTE CONTROL SRCD-4400 ST Press the TUNING-Up Button 1 or TUNING-DOWN Button 2 to find the desired station. If the BAND Switch is set to the FM STEREO positing and you have tuned to an FM Stereo station, the FM STEREO LED Indicator will light. When you have finished listening, Slide the POWER switch to the OFF position to shut the power off. 22. CD Skip/Forward ( ) Button Hints for Better Reception Install battery 1. Insert two AAA batteries (not included) correctly so that the + and - polarities match the polarity diagrams inside the battery compartment. Note: * About half a year of normal operation can be expected when using the general batteries. * When the batteries are exhausted, the commander should no longer operate the system. * When the commander is not to be use for a long time, remove the batteries to avoid damage caused by battery leakage and corrosion. * Avoid keeping the commander in extremely hot or humid locations. , , * Between remote controller and remote sensor there should be no obstacle and have to within 30 range. , * The remote controller s operating distance is about 0. 2M to 6M away from the remote sensor. FM - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may have to vary the direction of the antenna to find the strongest signal for each FM station. And Slide the FUNCTION Switch to the TAPE position. Press the STOP/EJECT ( ) Button to open the Cassette Door. (2) Use the or buttons to select the first track to be programmed. 7 indicator does not flash in the display. 4 5 6 (3) Press the MEMORY button again. This will store track 7 into program memory number 1. And Press or buttons the display will now select the track to be entered into program memory 2. . MEMORY 2 1 2 Emptiest reel (4) Repeat steps (2. ) And (3. ) Until you have programmed up to a maximum of 16 tracks into the program memory. (5) To begin Programmed Playback press the button. The MEMORY Indicator stops flashing and remains On . The player will begin to play the tracks in the order that you selected. , Insert a pre-recorded cassette into the slots in the Cassette Door with the open end facing up and the full reel on the right side. Close the cassette door. Press the cassette Play ( ) Button 1 to begin playback. Adjust the VOLUME 2 To advance or rewind the tape rapidly, press either the cassette Fast Forward ( ) 1 or Rewind ( ) 2 button. When you reach the desired point, press the cassette play ( ) Button 3 to resume normal playback. 7 8 9 To pause playback momentarily , press the cassette Pause ( ) Button. The tape movement stops but the tape motor is still running . Press the cassette Pause ( ) Button again to release Pause and resume normal playback . To stop playback before the tape ends, press the Stop/Eject ( ) Button. [. . . ] AM: Unit is not positioned correctly Rotate unit until best reception is obtained. Retune station, try another station or set BAND switch to FM STEREO. Slide the FUNCTION switch to the RADIO position. Increase Volume. FM STEREO indicator does not light. Poor FM signal being received or BAND switch is not set to FM STEREO. [. . . ]