User manual CURTIS TCR1276

[. . . ] For example, the appliance should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings, or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through the ventilation openings. Heat - The appliance should be situated away from neat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. . Power Sources - The product should be operated only with the type of power supply indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. [. . . ] Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Safety Check-Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operation condition. Overloading-Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fir or electric shock. NEC NATIONAL ELECTRICAL CODE Do not apply oil or petroleum products to this product. CAUTION Invisible laser radiation will be emitted when the product is open and interlocks are defeated. GRAPHIC SYMBOLS WITH SUPPLEMENTARY MARKINGS ARE LOCATED ON THE BOTTOM OF THE UNIT. USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. 1. AUTO/OFF/ON SWITCH POWER SOURCE Plug the AC line cord into AC 120V 60Hz power outlet. The unit is now working and the display figures will blink to show you it is operating, but not yet set. slide the switch to turn radio "ON", "OFF" or to "AUTO" position. When the switch is in the "AUTO" position, it will permit automatic turning "ON" and "OFF" of the radio according to the sleep and alarm settings. press this button simultaneously with the HOUR or MINUTE button to set the desired time. Press this button simultaneously with the HOPUR or 4. 5. 9. MINUTE button to set the desired wakeup time. Press this button to display the number of minutes (59 or less) where the radio will sound for 59 minutes and will automatically turn off after then. Use these buttons to set the time, while pressing the Alarm set button or Sleep button. Slide this selector to either AM or FM to select the desired radio band. To regulate the loudness of the radio, rotate the CONTROL clockwise to desired position. If you wish to be awakened preset time by the "Buzzer" rotate the CONTROL counter-clockwise until a "click sound is heard. Turn this knob to the desired radio station. When you are awakened by music or buzzer but wish to sleep a few to sleep a few minutes more, simply touch the "snooze" button and it will shut off the music or buzzer for approximately 5 to 10 minutes before the music or buzzer sounds again. [. . . ] BATTERY BACK-UP Your clock has a battery back up feature in case of power failure. A 9 volt battery (not included) is required. You must put in a battery to ensure the battery back up feature is ready in case of power failure. If power fails, the back up battery will automatically continue operation of the clock and maintain actual time. [. . . ]