User manual CYBERHOME CH-DVR 2500

[. . . ] TM Mini DVD with Player Progressive Scan TM TM CH -D V D 300 Theater Operation Guide CH-DVD 300 SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). REFER TO QUALIFIED SERVICE PERSONNEL FOR SERVICING. Explanation of warning symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of not isolated dangerous voltage within the inside of the product that may be sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the appliance. Read the following instructions carefully WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR ANNOYING INTERFERENCE, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE AND ONLY USE THE RECOMMENDED ACCESSORIES. Read these instructions - When using this unit, basic precautions outlined in this section should always be followed. Keep these instructions - Retain this user manual for future reference. [. . . ] These outputs require special cables not included. STEREO AUDIO IN TV, receiver or recording equipment with stereo audio in L R R AUDIO OUT VIDEO Y S-VIDEO Pb/Cb Pr/Cr L COAXIAL PROGRESSIVE SCAN COMPONENT VIDEO OUT COAXIAL DIGITAL AUDIO IN Receiver with Digital Audio Input 10 11 12 GETTING STARTED Powering on the unit Only after all connections are complete, connect the power cord and power on the unit. Inserting a disc 1 Press the OPEN/CLOSE button on the remote or front panel to open the disc tray. TM CH-DVD 300 POWER DISPLAY SETUP OPEN/CLOSE TITLE MENU PBC GOTO PROGRAM 1 2 3 Plug the standard electrical plug into a wall socket or power strip. Once the unit has been turned on, the unit will always be either ON, or in STANDBY MODE. Press STANDBY on the remote control or front panel to bring the system out of standby mode. The system is now ready to use. ANGLE SUBTITLE AUDIO MUTE 2 Insert the disc, being careful not to touch the playing surface. Hold the disc by the sides and with your fore finger through the hold in the middle and insert gently into the tray. TM CH-DVD 300 Labeling Side Surface POWER DISPLAY SETUP OPEN/CLOSE TITLE MENU PBC GOTO PROGRAM ANGLE SUBTITLE AUDIO MUTE 3 Close the disc tray by pressing OPEN / CLOSE on the remote or front panel. Notes on power states There are three power states for this unit: OFF - The unit is not plugged into a wall outlet. STANDBY - The unit is plugged into a wall outlet. The unit has not been taken out of standby by pressing either the STANDBY key on the remote control or the ON / STANDBY button on the front panel. The unit draws a slight amount of power to enable the remote control receiving circuit. ON - The unit is plugged into wall outlet and either the STANDBY button on the remote control or the ON / STANDBY button on the front panel has been pressed. The LED is now glowing green. 13 DVD PLAYER OPERATION Using disc menus Playing a disc from the "root" menu Most DVDs will automatically display a menu after the disc is inserted. This first menu is the first of possibly many layers, and is therefore known as the "root" menu. Basic disc playback Starting, pausing and stopping disc play TM 1 Use the ARROW keys on the remote control to navigate through the menu to the appropriate selection to start the movie. CH-DVD 300 PLAY PLAY STOP ENTER PAUSE PLAY MOVIE SPECIAL FEATURES ENTER STOP SCENE SELECTION RETURN BOOKMARK ZOOM PAUSE 1 2 SLOW AUDIO SETUP RETURN BOOKMARK ZOOM SLOW 1 2 3 2 Press ENTER to confirm your selection. Accessing a menu after play has started 1 If you wish to re-enter the menu after disc play has 1 2 PLAY - To begin playback of a disc, press PLAY. STOP - To stop playback of a disc, press STOP. The first time STOP is pressed the location where disc play was halted is saved, and you can begin playback where you left off by pressing PLAY. If STOP is pressed twice, the playback location is reset to the beginning of the disc. PAUSE - To freeze disc playback on a single frame, press the PAUSE key. To resume normal playback, press PAUSE again, or press PLAY. started, use the MENU key. MENU also exits the menu at any time. With VCD discs, this button functions as PBC (Playback Control), enabling or disabling the PBC function. 3 POWER DISPLAY SETUP OPEN/CLOSE TITLE MENU PBC GOTO PROGRAM ANGLE SUBTITLE AUDIO MUTE About the screen saver When disc playback remains paused for a period of about 3 minutes, the screen saver will load, protecting the television from "screen burn", which could occur if an unusually bright image is displayed on-screen for an extended period of time. TM 2 Using the RETURN key 1 Use the RETURN key to go back to the previous layer of a menu. This function can be quite handy when using menus with many layers. PLAY STOP ENTER PAUSE RETURN BOOKMARK ZOOM SLOW 3 14 DVD PLAYER OPERATION Skipping to the next or previous chapter / track You can advance or skip back through the chapters or tracks on DVD discs, Audio CDs and other discs with the NEXT and PREVIOUS buttons on the remote control or front panel. 2 On the front panel, note that the FF and NEXT functions share the same button, and likewise for the FR and PREVIOUS functions. To begin FF or FR scanning, press the corresponding button. Repeat this procedure to cycle through all available speeds, and return to normal playback. TM Advanced playback Slow motion playback This unit supports slow motion playback of up to 1/32 normal speed. PLAY CH-DVD 300 PLAY 2 HOLD 1 STOP ENTER PAUSE STOP ENTER PAUSE RETURN BOOKMARK ZOOM SLOW 2 1 1 RETURN BOOKMARK ZOOM SLOW On the front panel, note that the FF and NEXT functions share the same button, and likewise for the FR and PREVIOUS functions. SKIP NEXT - To advance to the next chapter or track, press the NEXT button on the remote control or press and hold the NEXT button on the front panel. 1 Press the SLOW MOTION button repeatedly to step through all options for slow playback. With DVDs, you can choose from ½, 1/4, 1/8, 1/16 or 1/32 speeds. 2 SKIP PREVIOUS - Press the PREVIOUS button on the remote control or press and hold the PREVIOUS button on the front panel to skip back to the previous track. Jumping to a specific chapter or track You can jump directly to any title on DVD discs, or any track on Music CDs with the NUMBER keys. 1 4 7 C 2 5 8 3 6 9 10+ 1/ALL REPEAT Fast Forward and Fast Reverse You can scan through DVDs, VCDs and other discs in forward or reverse direction at speeds up to 32X (thirty-two times normal speed). [. . . ] The battery for the remote control may need to be changed. You may be out of range for the remote control, try to move closer. NO PICTURE ON THE SCREEN Ensure the connections from the DVD player to the TV are secure. Verify the TV's channel is set to match the video input your are using. Please refer to your TV's documentation. [. . . ]