User manual CYBEX INTERNATIONAL 11000_CHEST PRESS

[. . . ] Cybex Eagle® Chest Press Owner's Manual Strength Systems Part Number 11000-999-4 A www. cybexinternational. com Cybex Eagle® Chest Press Owner's Manual Strength Systems Part Number 11000-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. With an assistant, carefully remove the six BHSCS securing the two halves of the frame. With an assistant, carefully attach each half together using the six BHSCS removed in step 4I. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4G and 4H. Reconnect pulley/cable to pulley bracket (removed in steps 4E and 4F). Verify the two belts are routed properly (one belt from the cam to the pulley bracket and the other belt connecting to the arms). Connect the weight stack belt to the belt clamp of cam (removed in step 4C). Install rubber feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Assembly Page 2 Phillips Head Screw (3) Figure 5 Figure 4 BHSCS (qty 6) Figure 3 Pivot Shaft Pulley Shaft Bolt Figure 2 Figure 1 Set Screws Cam Hex Nut/Washer Pulley Bracket BHSCS J. Carefully move each half through the door-way to the desired location. Nylon Locknut (6) Cybex Eagle 11000 Chest Press Owner's Manual F. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 6. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud. Carefully slide rear shroud assembly upward and remove. Figure 6 Screw (loosen do not remove) 6. Note how the increment weights are installed. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance 5 Cybex Eagle 11000 Chest Press Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]