User manual CYBEX INTERNATIONAL 11010_OVERHEAD PRESS

[. . . ] Cybex Eagle® Overhead Press Owner's Manual Strength Systems Part Number 11010-999-4 A www. cybexinternational. com Cybex Eagle® Overhead Press Owner's Manual Strength Systems Part Number 11010-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Remove bolt, washer and hex nut securing the pulley to the pulley bracket. Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. Hex Nut/Washer Pulley Bracket Cam Set Screws Figure 1 Cam J. With an assistant, carefully remove the five BHSCS securing the two halves of the frame. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the five BHSCS removed in step 4J. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4H and 4I. Reconnect pulley bracket (removed in steps 4F and 4G). Verify the two belts are routed properly (one belt from the cam to the pulley bracket and the other belt connecting to the arms). Connect the weight stack belt to the belt clamp of cam (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Nylon Locknut (3) Figure 3 Figure 2 Bolt BHSCS Washer Pulley Shaft Nylon Locknut (2) BHSCS (qty 3) BHSCS (qty 2) Figure 4 Assembly Page 4-2 Cybex Eagle 11010 Overhead Press Owner's Manual E. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 6. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud. Carefully slide rear shroud assembly upward and remove. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11010 Overhead Press Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]