User manual CYBEX INTERNATIONAL 11030_ROW

[. . . ] Cybex Eagle® Row Owner's Manual Strength Systems Part Number 11030-999-4 A www. cybexinternational. com Cybex Eagle® Row Owner's Manual Strength Systems Part Number 11030-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Remove one of the two BHSCS securing the pivot shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. Rotate cam so that the flat part is facing down. Carefully slide pulley shaft out of machine. Cam Cover Plate Figure 3 Screw BHSCS (2) Small Plate Figure 4 Washer BHSCS Pulley Shaft Pivot Shaft Pulley/Cable Figure 5 Assembly Page 4-2 Cybex Eagle 11030 Row Owner's Manual O. With an assistant, carefully remove the six BHSCS securing the two halves of the frame. Carefully lay the taller half of the frame down on the floor until you are ready to move it. Carefully move each half through the door-way to the desired location. Again, lay the taller half of the frame down on the floor until you are ready to reattach the two halves. With an assistant, carefully attach each half together using the six BHSCS removed in step 4O. With the flat part facing down, carefully slide the pulley shaft back into the machine (removed from steps 4M and 4N). Carefully slide the pivot shaft through the pulley shaft (removed from steps 4K and 4L). Secure the pivot shaft using the BHSCS removed in step 4K. Reconnect the pulley to the pulley bracket (removed in steps 4F and 4G). Verify the two belts are routed properly (one belt connecting from the cam to the pulley bracket and the other belt connecting from the pulley to the arms). Connect the weight stack belt to the belt clamp of cam (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. Figure 9 BHSCS (qty 6) Nylon Locknut (6) Figure 6 Phillips Head Screw (3) Figure 7 Screw (loosen do not remove) Figure 8 Screw D. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11030 Row Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]