User manual CYBEX INTERNATIONAL 11040_LEG PRESS

[. . . ] Cybex Eagle® Leg Press Owner's Manual Strength Systems Part Number 11040-999-4 A www. cybexinternational. com Cybex Eagle® Leg Press Owner's Manual Strength Systems Part Number 11040-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Locate the belt attached near the adjusting tube. Remove belt from clamp and "unroute" belt so that it can be easily removed from the machine when pulley shaft is removed. Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Figure 1A Phil Hex Washer (5) Shield Cam Set Screws Shield Figure 1B J. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. With an assistant, carefully remove the eight BHSCS securing the two halves of the frame. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the eight BHSCS removed in step 4K. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4I and 4J. Properly route and connect belt to belt clamp (removed in step 4H). Connect the weight stack belt to the belt clamp of cam (removed in step 4E). Install shield and secure using the five Phillips head screws (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support) using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Nylon Locknut (8) Figure 3 BHSCS Washer Pulley Shaft Pivot Shaft Belt Set Screws Figure 2 BHSCS (qty 8) Figure 4 Assembly Page 4-2 Cybex Eagle 11040 Leg Press Owner's Manual E. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 6. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11040 Leg Press Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]