User manual CYBEX INTERNATIONAL 11060_SEATED LEG CURL

[. . . ] Cybex Eagle® Seated Leg Curl Owner's Manual Strength Systems Part Number 11060-999-4 A www. cybexinternational. com Cybex Eagle® Seated Leg Curl Owner's Manual Strength Systems Part Number 11060-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] BHSCS (2) Figure 1 BHSCS (4) Locknut (2) BHSCS (4) Locknut (4) (not shown) Locknut (4) Assembly Page 4-1 Cybex Eagle 11060 Seated Leg Curl Owner's Manual C. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the ten BHSCS removed in step 4B. Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support (using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 3. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud assembly. Carefully slide rear shroud assembly upward and remove. Note how the increment weights are installed. With an assistant holding the increment weights, move the adjusting knob to 0 lbs. and remove all six increment weights (three each side). Using an external snap ring pliers, remove the upper snap ring from one of the guide rods and carefully lower the guide rod. Remove lower snap ring and wave washer from the guide rod. Repeat steps 6C and 6D to remove both snap rings from other guide rod. If possible, lean guide rods outward, away from machine in order to provide the most room for installing weight plates. Slide top weight up and out of machine and carefully set it aside. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive engine oil. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11060 Seated Leg Curl Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]