User manual CYBEX INTERNATIONAL 11080_ARM EXTENSION

[. . . ] Cybex Eagle® Arm Extension Owner's Manual Strength Systems Part Number 11080-999-4 A www. cybexinternational. com Cybex Eagle® Arm Extension Owner's Manual Strength Systems Part Number 11080-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Remove pulley then remove other end of belt from cam. Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. With an assistant, carefully remove the six BHSCS securing the two halves of the frame. BHSCS Pulley Shaft Figure 2 Hex Nut Shoulder Bolt J. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the six BHSCS removed in step 4I. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4G and 4H. Reconnect belt to cam and reinstall pulley (removed in step 4F). Connect other end of belt to the arm using the BHSCS and nylon locknut from step 4E. Connect the weight stack belt to the belt clamp of cam (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support) using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Figure 4 Washer Pulley/Cable Pivot Shaft BHSCS (qty 3) BHSCS (qty 3) Nylon Locknut (6) Phillips Head Screw (3) Figure 5 Assembly Page 4-2 Cybex Eagle 11080 Arm Extension Owner's Manual F. Loosen bottom two screws shown in Figure 6. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud. Carefully slide rear shroud assembly upward and remove. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11080 Arm Extension Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]