User manual CYBEX INTERNATIONAL 11130_LAT PULL

[. . . ] Cybex Eagle® Pulldown Owner's Manual Strength Systems Part Number 11130-999-4 A www. cybexinternational. com Cybex Eagle® Pulldown Owner's Manual Strength Systems Part Number 11130-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Cut shipping tie securing top weight. Assembly Page 4-1 Cybex Eagle 11130 Pulldown Owner's Manual D. Rotate cam and disconnect weight stack belt from cam (by loosening the two set screws on the belt clamp with a 7/32" Allen wrench). Locate the pulley bracket that is located near the cam. Remove bolt, washer and hex nut securing the pulley to the pulley bracket. Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. Cable Figure 2 Set Screws Figure 1 Cam Cam Bolt Nylon Locknut J. With an assistant, carefully remove the five BHSCS securing the two halves of the frame. Carefully move each half through the door-way to the desired location. Washer Pulley/Cable L. With an assistant, carefully attach each half together using the five BHSCS removed in step 4J. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4H and 4I. Reconnect pulley/cable to pulley bracket (removed in steps 4F and 4G). Connect the weight stack belt to the belt clamp of cam (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support) using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Figure 5 Assembly Page 4-2 Phillips Head Screw (3) Figure 4 BHSCS (qty 3) Nylon Locknut (2) Nylon Locknut (3) Figure 3 Pivot Shaft BHSCS Pulley Shaft Washer BHSCS (qty 2) Cybex Eagle 11130 Pulldown Owner's Manual F. Loosen bottom two screws shown in Figure 6. NOTE: Do not remove the bottom two screws. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11130 Pulldown Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]