User manual CYBEX INTERNATIONAL 11170_GLUTE

[. . . ] Cybex Eagle® Glute Owner's Manual Strength Systems Part Number 11170-999-4 A www. cybexinternational. com Cybex Eagle® Glute Owner's Manual Strength Systems Part Number 11170-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] NOTE: If your machine fits through the doorway then skip step 4. If your machine does not fit through the doorway then perform step 4. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Assembly Page 4-1 Cybex Eagle 11170 Glute Owner's Manual B. With an assistant, carefully remove the six Button Head Socket Cap Screws (BHSCS) securing the two halves of the frame. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the six BHSCS removed in step 4B. Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support (using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 3. NOTE: Do not remove the bottom two screws. Remove the top two screws securing the back shroud assembly. Carefully slide rear shroud assembly upward and remove. Note how the increment weights are installed. With an assistant holding the increment weights, move the adjusting knob to 0 lbs. and remove all six increment weights (three each side). Using an external snap ring pliers, remove the upper snap ring from one of the guide rods and carefully lower the guide rod. Remove lower snap ring and wave washer from the guide rod. Repeat steps 6C and 6D to remove both snap rings from other guide rod. If possible, lean guide rods outward, away from machine in order to provide the most room for installing weight plates. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11170 Glute Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]