User manual CYBEX INTERNATIONAL 11190_TORSO

[. . . ] Cybex Eagle® Torso Rotation Owner's Manual Strength Systems Part Number 11190-999-4 A www. cybexinternational. com Cybex Eagle® Torso Rotation Owner's Manual Strength Systems Part Number 11190-999-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Eagle® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] This will assist you in reinstalling them properly. Cut shipping tie securing top weight. Assembly Page 4-1 Cybex Eagle 11190 Torso Rotation Owner's Manual D. Rotate cam and disconnect weight stack belt from cam (by loosening the two set screws on the belt clamp with a 7/32" Allen wrench). Remove one of the two BHSCS (Button Head Socket Cap Screws) securing the pivot shaft. Carefully remove pivot shaft and pulley shaft. NOTE: Be extremely careful when removing shaft so you don't ruin the threads on the shaft. With an assistant, carefully remove the eight BHSCS securing the two halves of the frame. Carefully move each half through the door-way to the desired location. With an assistant, carefully attach each half together using the eight BHSCS removed in step 4G. Figure 2 Figure 1 Cam Set Screws BHSCS Washer Pivot Shaft Pulley Shaft J. Carefully attach pulley shaft using the pivot shaft and BHSCS removed in steps 4E and 4F. Connect the weight stack belt to the belt clamp of cam (removed in step 4D). Remove shipping feet and remove the back shrouds. Carefully remove each (standard) cone-shaped shipping support) using a 3/4" socket or wrench). Carefully place rubber feet (supplied with machine) on each foot of the frame. Lift top weight and turn the Increment Weight Adjusting Knob to select all 15 lbs. Remove the three Phillips head screws securing the top (back) shroud and carefully remove the shroud. Loosen bottom two screws shown in Figure 5. NOTE: Do not remove the bottom two screws. BHSCS (qty 6) BHSCS (qty 2) Nylon Locknut (2) Nylon Locknut (6) Figure 3 Phillips Head Screw (3) Figure 4 Screw (loosen do not remove) Figure 5 Assembly Page 4-2 Cybex Eagle 11190 Torso Rotation Owner's Manual G. Remove the top two screws securing the back shroud. Carefully slide rear shroud assembly upward and remove. Note how the increment weights are installed. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-5 Cybex Eagle 11190 Torso Rotation Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]