User manual CYBEX INTERNATIONAL 12200 HIP ABDUCTION

[. . . ] Cybex VR3® Hip Abduction Owner's Manual Strength Systems Part Number 12200-999-4 H www. cybexinternational. com Cybex VR3® Hip Abduction Owner's Manual Strength Systems Part Number 12200-999-4 H Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Read and understand all instructions thoroughly before starting any of the procedures listed on this instruction sheet. Verify you have received the appropriate configuration. Verify that you received the correct color machine that you ordered. Verify you received the proper weight stack. Verify you received the appropriate owner's manual. Verify you received the weight stack decals. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. If weight stack is already installed, proceed to step 9. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: Do not remove middle BHSCS securing shroud to bottom bracket. Remove the remaining BHSCS securing the back shroud to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. Assembly Page 4-1 Cybex VR3 12200 Hip Abduction Owner's Manual D. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Top guide rod cap is spring loaded. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Remove guide rod cap and spring and set aside. Carefully lean guide rods slightly outward, away from machine to clear pulley. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. J. Slide top weight up and out of machine and carefully set it aside. [. . . ] When inspecting cables, run your fingers on the cable, paying particular attention to bends in the cable and attachment points. WARNING: Replace all worn cables immediately. The following conditions may indicate a worn cable: · A tear or crack in the cable sheath that exposes the cable. See Figure 1. Figure 1. · A kink in the cable. See Figure 2. Figure 2. · A curled sheath. [. . . ]