User manual CYBEX INTERNATIONAL 12220 CABLE COLUMN

[. . . ] Cybex VR3® Cable Column Owner's Manual Strength Systems Part Number 12220-999-4 H www. cybexinternational. com Cybex VR3® Cable Column Owner's Manual Strength Systems Part Number 12220-999-4 H Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Concealed damage claim is the carrier's responsibility. Cybex, if applicable. Under no circumstances will defective parts or equipment be accepted by Cybex without proper RMA and an Automated Return Service (ARS) label. Customer Service Page 3-2 Cybex VR3 12220 Cable Column Owner's Manual 4 - Assembly TOOLS REQUIRED ITEM QTY 5 4 1 14 1 2 3 PART NO. 12090-322 PR070004 9100-313 4000C101 DESCRIPTION FOOT PAD FOOT PAD DECAL, WEIGHT PLATE (1-25) WEIGHT STACK PLATE 4 · · · · · 7/32" Allen wrench 1/8" Allen wrench Medium weight automotive engine oil Torque wrench 3/4" Wrench 1 2 3 4 NOTE: Two people will be required for this procedure. NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance around each machine to allow for safe use and passage. Read and understand all instructions thoroughly before starting any of the procedures listed on this instruction sheet. Verify you have received the appropriate configuration. Verify that you received the correct color machine that you ordered. Verify you received the proper weight stack. Verify you received the appropriate owner's manual. Verify you received the weight stack decals. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. If weight stack is already installed, proceed to step 9. B. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: Do not remove middle BHSCS securing shroud to bottom bracket. Remove the remaining BHSCS securing the back shroud to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. Assembly Page 4-1 Cybex VR3 12220 Cable Column Owner's Manual D. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Top guide rod cap is spring loaded. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. [. . . ] When inspecting cables, run your fingers on the cable, paying particular attention to bends in the cable and attachment points. WARNING: Replace all worn cables immediately. The following conditions may indicate a worn cable: · A tear or crack in the cable sheath that exposes the cable. See Figure 1. Figure 1. · A kink in the cable. See Figure 2. Figure 2. · A curled sheath. [. . . ]