User manual CYBEX INTERNATIONAL 13130 LAT PULL

[. . . ] VR1® Lat Pull Owner's and Service Manual Strength Systems Part Number 13130-999-4 C www. cybexinternational. com VR1® Lat Pull Owner's and Service Manual Strength Systems Part Number 13130-999-4 C Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR1® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] NOTE: If weight stacks need to be installed proceed to step 8. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. NOTE: It is important that you perform regular inspection and maintenance activities on your equipment. See the CYBEX VR1 Owner's Manual for inspection and maintenance activities. If you do not have a CYBEX Owner's Manual or if you have any questions or concerns, Call Cybex Customer Relations at 888-462-9239. Assembly Page 4-1 Cybex VR1 13130 Lat Pull Owner's Manual 5. Securely anchor machine to the floor using the anchor holes provided in each machine. NOTE: Cybex is not responsible for the actual anchoring of equipment. NOTE: Use fasteners having a minimum of 500 lbs tensil capacity (3/8" grade 2 bolts or better). NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in contact with surface using flat washers. Using a 7/32" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the top cap to the frame. See Figure 1. BHSCS Shroud Top Cap Figure 1 B. Carefully lift shroud up and out of machine. Slide spring loaded guide rod cap down guide rod until cap is clear of frame. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Guide Rod Cap Guide Rod Cap Compression Spring Figure 2 Guide Rods Compression Spring Assembly Page 4-2 Cybex VR1 13130 Lat Pull Owner's Manual F. Remove guide rod cap and spring and set aside. Repeat steps 7D - 7F for other guide rod. Using a 3/16" pin punch and hammer, carefully remove roll pin securing cable end to top weight connector. Carefully lean guide rods slightly outward. [. . . ] You may notice a static build-up just by walking across a carpet and then touching a metal object. The same can hold true while working out on your unit. You may experience a shock due to the build-up of static electricity on your body and the discharge path of the unit. If you experience this type of situation, you may want toincrease the humidity to a comfortable level through the use of a humidifier. [. . . ]