User manual CYBEX INTERNATIONAL 14010 OVERHEAD PRESS

[. . . ] Cybex Total Access Overhead Press Owner's and Service Manual Strength Systems Part Number 14010-999-4 F www. cybexinternational. com Cybex Total Access Overhead Press Owner's and Service Manual Strength Systems Part Number 14010-999-4 F Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Concealed damage claim is the carrier's responsibility. Cybex, if applicable. Under no circumstances will defective parts or equipment be accepted by Cybex without proper RMA and an Automated Return Service (ARS) label. Customer Service Page 3-2 Cybex Total Access 14010 Overhead Press Owner's Manual 4 - Assembly TOOLS REQUIRED · · · · · 7/32" Allen wrench 1/8" Allen wrench Medium weight automotive engine oil Torque wrench 3/4" Wrench ITEM 1 2 3 4 1 QTY 2 4 1 9 PART NO. 12090-322 12000-345 14000-401 4000C101 2 3 DESCRIPTION FOOT PAD FOOT PAD DECAL, WEIGHT PLATE WEIGHT STACK PLATE 4 NOTE: Two people will be required for this procedure. NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance around each machine to allow for safe use and passage. 1. Read and understand all instructions thoroughly before starting any of the procedures listed on this instruction sheet. erifyyouhavereceivedtheappropriateconfiguration. Verify that you received the correct color machine that you ordered. Verify you received the proper weight stack. Verify you received the appropriate owner's manual. Verify you received the weight stack decals. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. If weight stack is already installed, proceed to step 9. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: Do not remove middle BHSCS securing shroud to bottom bracket. Remove the remaining BHSCS securing the back shroud to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. Carefully slide shroud out of machine. 30 50 70 90 110 130 150 170 190 210 230 250 270 290 310 330 350 370 390 410 430 450 470 490 14 23 32 41 50 59 68 77 86 95 104 113 122 131 140 149 158 167 176 185 194 203 212 221 Assembly Page 4-1 Cybex Total Access 14010 Overhead Press Owner's Manual E. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Top guide rod cap is spring loaded. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-9 Cybex Total Access 14010 Overhead Press Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]