User manual CYBEX INTERNATIONAL 14051 LEG EXTENSION

[. . . ] Cybex Total Access Leg Extension Owner's and Service Manual Strength Systems Part Number 14051-999-4 F www. cybexinternational. com Cybex Total Access Leg Extension Owner's and Service Manual Strength Systems Part Number 14051-999-4 F Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Verify you received the proper weight stack. Verify you received the appropriate owner's manual. Verify you received the weight stack decals. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. If weight stack is already installed, proceed to step 9. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: Do not remove middle BHSCS securing shroud to bottom bracket. Remove the remaining BHSCS securing the back shroud to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. Carefully slide shroud out of machine. Assembly Page 4-1 Cybex Total Access 14051 Leg Extension Owner's Manual E. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Top guide rod cap is spring loaded. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Remove guide rod cap and spring and set aside. Carefully lean guide rods slightly outward, away from machine to clear pulley. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. J. Slide top weight up and out of machine and carefully set it aside. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive engine oil. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-9 Cybex Total Access 14051 Leg Extension Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]