User manual CYBEX INTERNATIONAL 14220 CABLE COLUMN

[. . . ] Cybex Total Access Cable Column Owner's and Service Manual Strength Systems Part Number 14220-999-4 E www. cybexinternational. com Cybex Total Access Cable Column Owner's and Service Manual Strength Systems Part Number 14220-999-4 E Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. VR3® and its mark are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. [. . . ] Verify you received the proper weight stack. Verify you received the appropriate owner's manual. Verify you received the weight stack decals. WARNING: Use extreme caution when removing shipping cones and installing feet. Failure to do so could result in injury. With an assistant, carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench. Carefully place rubber feet (supplied with machine) on each foot of the frame. If weight stack is already installed, proceed to step 9. Using a 1/8" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the bottom bracket to the frame. NOTE: Do not remove middle BHSCS securing shroud to bottom bracket. Remove the remaining BHSCS securing the back shroud to the frame. NOTE: After final BHSCS is removed shroud will slide down to the floor with bottom support bracket attached. 30 50 70 90 110 130 150 170 190 210 230 250 270 290 310 330 350 370 390 410 430 450 470 490 14 23 32 41 50 59 68 77 86 95 104 113 122 131 140 149 158 167 176 185 194 203 212 221 Assembly Page 4-1 Cybex Total Access Cable Column Owner's Manual D. Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame. NOTE: Top guide rod cap is spring loaded. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Remove guide rod cap and spring and set aside. Carefully lean guide rods slightly outward, away from machine to clear pulley. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. J. Carefully hang over top of machine so cables and top weight are out of the way when installing weight plates. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive engine oil. Have an assistant hold the guide rods vertical. [. . . ] See Figure 3. Figure 3 · "Necking", a stretched cable sheath. See Figure 4. Figure 4 Maintenance Page 5-9 Cybex Total Access 14220 Cable Column Owner's Manual 4. Inspect bars and handles for wear, paying particular attention to tab area connecting points. Inspect snap links for proper latching (indicates wear). [. . . ]