User manual CYBEX INTERNATIONAL 425T TREADMILL

[. . . ] Cybex LCX-425T Treadmill Owner's Manual Cardiovascular Systems Part Number LT-19341-4 G www. cybexinternational. com Cybex LCX-425T Treadmill Owner's Manual Cardiovascular Systems Part Number LT-19341-4 G Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Polar® is a registered trademark of Polar Electro Inc. makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. [. . . ] Press the Speed + -- keys to change the belt speed at any time. The right display will show the current speed. Press the Incline V keys to change the incline at any time. The left display will show the current incline on the first press of the key. Press the Pause/Stop key at any time to stop the running belt and return the incline to 0%. Press again to exit to Dormant Mode. Detailed Operation Guide NOTE: Maximum user weight is 350 lbs. NOTE: The unit does not have an on/off switch. Plugging the treadmill into a power outlet will supply power to the treadmill and will illuminate the control panel. 1. Plug the treadmill power cord into a power outlet from a grounded, dedicated circuit, rated for one of the following: 115 VAC ±5%, 60 Hz and 15 amps; 208/220 VAC, 60 Hz, 10 amps or 230 VAC ±5%, 50 Hz and 10 amps. Operation Page 3-2 Cybex 425T Treadmill Owner's Manual WARNING: Do not stand on the running belt when starting the treadmill. Always place your feet on the two top steps when beginning a workout. 2. Place your feet on the two top steps located on each side of the running belt. Clip the e-stop clip onto your clothing and carefully test the e-stop key to ensure it will activate in case of an emergency. See Emergency Stop Key (e-stop) in Chapter 1 for properly testing the e-stop key. Also, see Stopping the Treadmill in this chapter for further information about the e-stop key. NOTE: Be sure the string is free of knots and has enough slack for you to run comfortably with the e-stop key in place. You now have the option to select a program or enter Manual Mode. To select a program, press the Programs key and follow the prompts. Press the Programs key multiple times to cycle through the eight programs, or use the center V keys. Upon entering a program the LEDs flash, prompting you to adjust the appropriate settings. This is referred to as Program Setup Mode. If the Quick Start key is pressed now, all defaults for that program will be accepted. After 10 seconds, if no key has been pressed, the first default will be accepted. [. . . ] Provide the model and serial number of your treadmill. The serial number is located on the front panel of your treadmill. The serial number begins with a letter, for example: R09-101331100. At Cybex's discretion, the technician may request that you return the problem part(s) to Cybex for evaluation and repair or replacement. [. . . ]