User manual CYBEX INTERNATIONAL 445T TREADMILL

[. . . ] Cybex CX-445T Treadmill Owner's Manual Cardiovascular Systems Part Number LT-19800-4 I www. cybexinternational. com Cybex CX-445T Treadmill Owner's Manual Cardiovascular Systems Part Number LT-19800-4 I Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. Safety SentryTM is a registered trademark of Cybex international, Inc. Polar® is a registered trademark of Polar Electro Inc. makes no representations or warranties regarding the contents of this manual. [. . . ] Clip the e-stop clip onto your clothing and test it as described under Emergency Stop in the Safety chapter. Press any program key or press Quick Start to skip the settings and begin Manual Mode immediately. If you pressed a program key to select a program, you will now be prompted for workout Time, Level and Weight as appropriate. Adjust these settings with the st arrows and press Enter to proceed. The treadmill begins a countdown, "3. . . 2. . . 1, " after which it accelerates the belt to 0. 5 mph (0. 8 kph) (for Manual Mode) or the speed of the program that you selected. Hold the handrails while you step onto the running belt and begin walking. Press the Speed + -- keys to change the belt speed at any time. The right display will show the current speed. Press the Incline V keys to change the incline at any time. The left display will show the current incline on the first press of the key. Press the Pause/Stop(Stop) key at any time to stop the running belt. Press again to exit to Dormant Mode. 3. 4. 5. 6. 7. 8. 9. Detailed Operation Guide NOTE: Maximum user weight is 350 lbs. Plug the treadmill power cord into a power outlet from a grounded, dedicated circuit, rated for one of the following: 115 VAC ±5%, 60 Hz and 20 amps; 220 VAC, 60 Hz, 12 amps or 230 VAC ±5%, 50 Hz and 12 amps. Locate the on/off (I/O) power switch under the right side rails of the treadmill. Toggle it to the on (I) position to supply power to the internal treadmill components and illuminate the control panel. 2. Operation Page 3-2 Cybex 445T Treadmill Owner's Manual WARNING: Do not stand on the running belt when starting the treadmill. Always place your feet on the two top steps when beginning a workout. Place your feet on the two top steps located on each side of the running belt. Clip the e-stop clip onto your clothing and carefully test the e-stop key to ensure it will activate in case of an emergency. See Emergency Stop Key (e-stop) in Chapter 1 for properly testing the estop key. Also, see Stopping the Treadmill in this chapter for further information about the e-stop key. NOTE: Be sure the string is free of knots and has enough slack for you to run comfortably with the e-stop key in place. [. . . ] At Cybex's discretion, the technician may request that you return the problem part(s) to Cybex for evaluation and repair or replacement. The technician will assign you an RMA number and will send you an ARS label. The ARS label and RMA number must be clearly displayed on the outside of the package that contains the item(s) to be returned. Include a description of the problem, the serial number of the treadmill and the name and address of the owner in the package along with the part(s). [. . . ]