User manual CYBEX INTERNATIONAL 8800 SERIES

[. . . ] Product Number 8800/8810/8830/8840 Medical Owner's Manual Strength Systems Part Number 8800-888-4 A www. cybexinternational. com Product Number 8800/8810/8830/8840 Medical Owner's Manual Strength Systems Part Number 8800-888-4 A Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. Printed in the United States of America. [. . . ] The solid, level surface should not deviate more than 1/8" over a 10' distance or as defined and required by local building and architectural codes. Anchoring of equipment must be completed by a qualified licensed contractor. Anchoring holes are provided on the feet of the frame. All anchoring locations must be used when anchoring the equipment to the floor. Due to the wide variation of flooring on which machines may be anchored or installed, verify anchoring method and anchoring fasteners with a qualified and licensed contractor. A minimum pull out force of 220 lbs/100 kgs is required for each anchor position. Do not use machine until it is properly anchored. Maintenance: Preventative maintenance allows proper equipment operation and reduces the risk of injury. Perform the maintenance requirements as specified in the manual. Standard Compliance: Cybex products meet or exceed applicable ASTM and EN Standards. Safety Page 1-3 Cybex Product Number 8800/8810/8830/8840 Medical Owner's Manual Warning/Caution Decals Warning decals indicate a potentially hazardous situation, which, if not avoided, could result in death or serious injury. Caution decals indicate a potentially hazardous situation, which, if not avoided, could result in minor or moderate injury. The warning and caution decals are shown on the following page. The diagrams following the decals show where each decal is located. A B C Safety Page 1-4 Cybex Product Number 8800/8810/8830/8840 Medical Owner's Manual 8800/8810 B C B A B (both sides) B (both sides) Description Part No. A. Warning Label. . . . . . . . . . . . . . . . . . . . 4605-381 B. Caution Decal. . . . . . . . . . . . . . . . . . . . . 8500-025 C. Caution Decal. . . . . . . . . . . . . . . . . . . . . 8800-442 Safety Page 1-5 Cybex Product Number 8800/8810/8830/8840 Medical Owner's Manual Regular Maintenance Activities Preventative maintenance activities must be performed to maintain normal operation of your equipment. Keeping a log sheet of all maintenance actions will assist you in staying current with all preventative maintenance activities. The preventative maintenance actions are described in detail in Chapter 4. Inspect all nuts and bolts for looseness. Inspect all cables and belts for damage or wear (see Chapter 4). If a cable or belt is worn or damaged, immediately discontinue use until cable or belt has been replaced. Check for worn handles, worn snap links, and worn warning labeling. [. . . ] The following conditions may indicate a worn cable: · A tear or crack in the cable sheath that exposes the cable. See Figure 1. Figure 1 · A kink in the cable. See Figure 2. Figure 2 · A curled sheath. See Figure 3. Figure 3 · "Necking", a stretched cable sheath. [. . . ]