User manual CYBEX INTERNATIONAL 8800 SERIES FUNCTIONAL TRAINER

[. . . ] Product Number 8800/8810/8830/8840 Owner's Manual Strength Systems Part Number 8800-999-4 G www. cybexinternational. com Product Number 8800/8810/8830/8840 Owner's Manual Strength Systems Part Number 8800-999-4 G Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc. DISCLAIMER: Cybex International, Inc. , makes no representations or warranties regarding the contents of this manual. We reserve the right to revise this document at any time or to make changes to the product described within it without notice or obligation to notify any person of such revisions or changes. © Copyright 2010, Cybex International, Inc. Printed in the United States of America. [. . . ] NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in contact with surface using flat washers. Using a 7/32" Allen wrench, remove the two Button Head Socket Cap Screws (BHSCS) securing the top cap to the frame. Carefully lift shroud up and out of machine. Slide spring loaded guide rod cap down guide rod until cap is clear of frame. NOTE: Guide rod cap contains a compression spring that will fly if grasp is not released slowly. Remove guide rod cap and spring and set aside. Repeat steps 6D - 6F for other guide rod. BHSCS Shroud Top Cap Figure 1 Guide Rod Cap Guide Rod Cap Compression Spring Guide Rods Compression Spring Figure 2 4-2 Product Number 8800/8810/8830/8840 Owner's Manual H. Using a 3/16" pin punch and hammer, carefully remove roll pin securing cable end to top weight connector. See Figure 3. Cable End Top Weight Connector Roll Pin Figure 3 I. Carefully lean guide rods slightly outward. NOTE: Excessive pressure on guide rods may damage lower guide rod caps. J. Slide top weight up and out of machine and carefully set aside. Have an assistant hold guide rods vertical. NOTE: Standard Weight Stack only - See steps 6L - 6P and Figures 4 and 7. NOTE: Graduated Weight Stack only - Skip steps 6L - 6P. Slide weight stack bumpers up and out of machine. Install washer (#14) and weight spacer tube (#12) onto each guide rod. Install the four plastic inserts (#11) onto each guide rod. NOTE: The plastic inserts will slide inside the weight spacer tube. Install flat washer (#13) onto each guide rod. Re-install weight stack bumpers. Weight Stack Bumper # 13 # 11 (4x) # 12 # 14 Guide Rod Figure 4 4-3 Product Number 8800/8810/8830/8840 Owner's Manual Q. [. . . ] Do not use if less than 1/8" of material remains to the edge. See Figure 5. Attachment Hole NOTE: Replace bar if less than 1/8" of material remains to the edge. Figure 5 4. Inspect snap links for proper latching (indicates wear) Replace all worn snap links immediately. Replace all loose or worn grips immediately. [. . . ]